Poulan 115274026 Manuel d'utilisateur télécharger pdf (Page 9)

OPERATION

KNOW YOUR UNIT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT.

Compare the illustrations with your unit to familiarize yourself with the location of the various controls

and adjustments. Save this manual for future reference.

Line Limiter

Blade

Primer Bulb

Handlebar

Throttle Trigger

Start Lever

Spark Plug

Shield

Trimmer Head

Shaft

ler

ON/STOP

Switch

Coupler

Starter Handle

Blade

ON/STOP S WITCH

The ON/STOP switch is located on the trigger

handle and is used to stop the engine. To stop

the engine, push and release the engine

ON/STOP switch .

PRIMER BULB

The PRIMER BULB removes air from the car-

buretor and fuel lines and fills them with fuel.

This allows you to start the engine with fewer

pulls on the starter rope. Activate the primer

bulb by pressing it and allowing it to return to

its original form.

START LEVER

The ST AR T LEVER helps to supply fuel to the

engine to aid in starting. Activate the starting

system by moving the start lever to the

ST ART position. DO NOT squeeze the

throttle trigger until the engine has started and

runs. After the engine starts, allow the engine

to warm--up 10--15 seconds, then fully

squeeze the throttle trigger to deactivate the

starting system.

COUPLER

The COUPLER enables optional attach-

ments to be installed on the unit.

BEFORE STARTING ENGINE

WARNING: Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING: Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2--cycle synthetic oil into

one gallon of fresh gas.

This engine is certified to operate on unleaded

gasoline. Before operation, gasoline must be

mixed with a good quality synthetic 2-cycle air-

cooled engine oil designed to be mixed at a ratio

of 40:1. Poulan/WEED EATER brand synthetic

oil is recommended. Mix gasoline and oil at a ra-

tio of 40:1. A 40:1 ratio is obtained by mixing 3.2

fluid ounces (95 ml) of oil with 1 gallon (4 liters)

of unleaded gasoline. DO NOT USE automotive

oil or marine oil. These oils will cause engine

damage. When mixing fuel, follow instructions

printed on container . Once oil is added to gaso-

line, shake container momentarily to assure that

the fuel is thoroughly mixed. Always read and

follow the safety rules relating to fuel before fuel-

ing your unit.

CAUTION: Never use straight gasoline in

your unit. This will cause permanent engine

damage and void the limited warranty.

FUEL REQUIREMENTS

This engine requires the use of minimum 87

octane [R+M]/2 clean gasoline.

IMPORTANT

Use of alcohol blended fuels (called gasohol or

using ethanol or methanol) can cause major en-

gine performance and durability problems.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Poulan 115274026 Manuel d'utilisateur Page 9

Commentaires sur ces manuels