Poulan 115274026 Manuel d'utilisateur télécharger pdf (Page 11)

11

WARNING: Always stop unit and dis-

connect spark plug before removing or instal-

ling attachments.

REMOVING TRIMMER ATTACH-

MENT (OR OTHER OPTIONAL

ATTA CHMENTS)

CAUTION:

When removing or installing at-

tachments, place the unit on a flat surface for

stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Attachment

Coupler

Knob

LOOSEN

TIGHTEN

2. Press and hold the locking/release button.

Locking/Release

Button

Coupler

Upper Shaft

Attachment

3. While securely holding the engine and

upper shaft, pull the attachment straight

out of the coupler.

INSTALLING OPTIONAL ATTACH-

MENTS

1. Remove the shaft cap from the attach-

ment (if present).

2. Position locking/release button of attach-

ment into guide recess of coupler.

3. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

4. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

WARNING: Make sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit. All attac hments ar e des igned

to be used in the primary hole unless otherwise

stated in the applicable attachment instruction

manual. Using the wrong hole could lead to seri-

ous injury or damage to the unit.

Locking/Release

Button in Primary Hole

OPERATING INSTRUCTIONS

It is recommended that the engine not be

operated for longer than 1 minute at full

throttle.

OPERATING POSITION

Boots

Heavy,

Long Pants

Eye Protection

ALWAYS WEAR:

Cut from your left to your right.

Hearing

Protection

When operating unit, clip shoulder strap onto

clamp, stand as shown and check for the fol-

lowing:

S Wear hearing protection, eye protection,

head protection and heavy clothing.

S Extend your left arm and hold handlebar

grip with your left hand.

S Hold throttle grip with your right hand with

finger on throttle trigger.

S Keep unit below waist level.

S Keep shoulder strap pad centered on your

left shoulder and danger sign centered on

your back.

S Maintain full weight of tool on your left

shoulder.

S Without bending over, keep the blade or

trimmer head near and parallel to the ground

and not crowded into material being cut.

OPERATING INSTRUCTIONS FOR

USE WITH TRIMMER HEAD

WARNING: Always wear eye protec-

tion. Never lean over the trimmer head. Rocks

or debris can ricochet or be thrown into eyes

and face and cause blindness or other serious

injury .

Before trimming, bring engine to a speed suffi-

cient to cut material to be trimmed.

Do not run the engine at a higher speed than

necessary. The cutting line will cut efficiently

when the engine is run at less than full throttle.

At lower speeds, there is less engine noise and

vibration. The cutting line will last longer and will

be less likely to “weld” onto the spool .

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Commentaires sur ces manuels

Pas de commentaire