Poulan 175680 Manuel d'utilisateur télécharger pdf (Page 14)

SERVICE AND ADJUSTMENTS

FIG. 22

SCREW

AND

WASHER

TO REMOVE BELT GUARD (See Fig. 22)

• Remove L.H. outer and inner side shields (See “TO

REMOVE WHEEL” in this section of this manaul).

• Remove hairpin clip and clevis pin from left wheel. Pull

wheel out from tiller about 1 inch.

• Remove two (2) screws and washers from side of belt

guard.

• Remove hex nut and washer from bottom of belt guard

(located behind wheel).

• Pull belt guard out and away from unit.

• Replace belt guard by reversing above procedure.

HEX NUT

AND

WASHER

(LOCATED

BEHIND

TIRE)

BELT GUARD

SCREW

AND WASHER

HAIRPIN CLIP AND

CLEVIS PIN

CABLE CLIP

SCREW

DRIVE

CONTROL

CABLE

EXTENSION

SPRING

ENGINE

PULLEY

IDLER

PULLEY

TRANSMISSION

PULLEY

LESS

TENSION

5/8"

TENSION

TO REPLACE GROUND DRIVE BELT (See

Fig. 23)

• Remove belt guard (See “TO REMOVE BELT GUARD”

in this section of this manual).

• Remove old belt by slipping off engine pulley first then

remove from transmission pulley.

• Place new belt in groove of transmission pulley and into

engine pulley. BELT MUST BE IN GROOVE ON TOP

OF IDLER PULLEY. NOTE POSITION OF BELT TO

GUIDES.

• Check belt adjustment as described below.

• Replace belt guard.

• Reposition wheel and replace clevis pin and hairpin clip.

• Replace inner and outer side shields.

GROUND DRIVE BELT ADJUSTMENT (See

Fig. 23)

For proper belt tension, the extension spring should have

about 5/8 inch stretch when drive control bar is in “EN-

GAGED” position. This tension can be attained as follows:

• Loosen cable clip screw securing the drive control cable.

• Slide cable forward for less tension and rearward for

more tension until about 5/8 inch stretch is obtained

while the drive control bar is engaged.

• Tighten cable clip screw securely.

FIG. 23

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Poulan 175680 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Poulan 175680