Poulan 115270726 Manuel d'utilisateur télécharger pdf (Page 11)

OPERATION

KNOW YOUR PRUNER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT.

Compare the illustrations with your unit to familiarize yourself with the location of the various controls

and adjustments. Save this manual for future reference.

Primer Bulb

Assist Handle

Throttle Trigger

Start Lever

Spark Plug

Sha

ler

ON/STOP

Switch

Coupler

Starter Handle

Attachment Hanger

Chain

Bar

Bar oil fill cap

Bar nut

Pruner

ON/STOP SWITCH

The ON/STOP switch is located on the trigger

handle and is used to stop the engine. To stop

the engine, push and release the engine ON/

STOP switch.

PRIMER BULB

The PRIMER BULB removes air from the car-

buretor and fuel lines and fills them with fuel.

This allows you to start the engine with fewer

pulls on the starter rope. Activate the primer

bulb by pressing it and allowing it to return to

its original form.

START L EVER

The ST AR T LEVER helps to supply fuel to the

engine to aid in starting. Activate the starting

system by m ovi ng the st art l ever to the STAR T

position. DO NOT squeeze the throttle trigger

until the engine has started and runs. After the

engine starts, allow the engine to warm--up 5

seconds, then fully squeeze the throttle trigger

to deactivate the starting system.

COUPLER

The COUPLER enables optional attach-

ments to be installed on the unit.

CHAIN TENSION

It is normal for a new chain to stretch during

first 15 minutes of operation. You should

check your chain tension frequently . See

CHAIN TENSION in the SERVICE AND AD-

JUSTMENTS section.

BEFORE STARTING EN GINE

WARNING: Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING: Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2-- cycle synthetic oil into

one gallon of fresh gas.

This engine is certified to operate on

unleaded gasoline. Before operation,

gasoline must be mixed with a good quality

synthetic 2-cycle air-cooled engine oil

designed to be mixed at a ratio of 40:1.

Poulan/WEED EATER brand synthetic oil is

recommended. Mix gasoline and oil at a ratio

of 40:1. A 40:1 ratio is obtained by mixing 3.2

fluid ounces (95 ml) of oil with 1 gallon (4

liters) of unleaded gasoline. DO NOT USE

automoti ve oil or ma rine oil. These oils will

cause engine damage. When mixing fuel, follow

instructions printed on container. Once oil is

added to gasoline, shake container momentarily

to assure that the fuel is thoroughly mixed.

Always read and follow the safety rules relating

to fuel before fueling your unit.

CAUTION: Never use straight gasoline in

your unit. This will cause permanent engine

damage and void the limited warranty.

FUEL REQUIREMENTS

This engine requires the use of minimum 87

octane [R+M]/2 clean gasoline.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Poulan 115270726 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Poulan 115270726