Poulan 115270726 Manuel d'utilisateur télécharger pdf (Page 9)

9

WARNING: Never lean over dis-

charge chute. Rocks or debris could be

thrown into the eyes and face and cause seri-

ous injury or blindness.

WARNING: Inspect the area where

the unit is to be used. Remove objects that

could be thrown or damage the unit. Some

objects may be hidden by fallen snow -- be

alert for the possibility.

S Direct material discharge away from glass

enclosures, automobiles, etc.

S Do not run engine at high speed while not

removing snow .

S Be attentive when using the snowthrower ,

and stay alert for holes in the terrain and

other hidden hazards.

S Make sure the rotor will spin freely before at-

taching the snowthrower to the powerhead.

S If the rotor will not rotate freely due to frozen

ice, thaw the unit before thoroughly before

attempting to operate under power .

S Keep the rotor clear of debris.

S Do not throw snow near other people. The

snow thrower could propel small objects at

high speed causing injury.

S After striking a foreign object, stop the en-

gine, disconnect spark plug and inspect the

snowthrower for damage and repair if nec-

essary before restarting unit.

S Never operate the snowthrower near glass

enclosures, automobiles and trucks.

S Never attempt to use the snowthrower on a

roof.

S Never operate the snowthrower near win-

dow wells, dropoffs, etc.

S Never discharge snow onto public roads or

near moving traffic.

S Clear snow from slopes by going up and

down; never across. Use caution when

changing directions. Never clear snow from

steep slopes.

S Let snowthrower run for a few minutes after

clearing snow so moving parts do not freeze.

S Look behind and use care when backing

up. Exercise caution to avoid slipping or fal-

ling, especially when operating in reverse.

S Know how to stop quickly.

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE: If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the

empty fuel tank.

Finding fuel or oil residue on muffler is normal

due to carburetor adjustments and testing

done by the manufacturer.

TOOLS REQUIRED

S Hex wrench (provided)

INSTALLING PRUNER ATTACH-

MENT

CAUTION:

When removing or installing at-

tachments, place the unit on a flat surface for

stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Shipping

protector

Coupler

Knob

LOOSEN

TIGHTEN

2. Remove shipping protector from coupler.

3. Remove the shaft cap from the pruner at-

tachment (if present).

4. Position locking/release button of attach-

ment into guide recess of coupler.

5. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

6. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

WARNING: Make sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit. Al l att ach ments are de signed

to be used in the primary hole unless otherwise

stated in the applicable attachment instruction

manual. Using the wrong hole could lead to seri-

ous injury or damage to the unit.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Commentaires sur ces manuels

Pas de commentaire