Poulan 115153026 Manuel d'utilisateur télécharger pdf (Page 10)

10

WARNING: The chain must not

move when the engine runs at idle speed. If

the chain moves at idle speed refer to CAR-

BURETOR ADJUSTMENT within this

manual. Avoid contact with the muf fler. A hot

muffler can cause serious burns.

To stop the engine move the ON/ST OP

switch to the STOP position.

To start the engine hold the saw firmly on the

ground as illustrated. Make sure the chain is

free to turn without contacting any obje ct.

Left Hand

on Front

Handle

Starter Rope Handle

Right Foot Through Rear Handle

Use only 15″ -- 1 8 ″ (40 -- 45 cm) of

rope per pull.

Hold saw firmly while pulling starter rope.

WARNING: Do not attempt to throw

or drop--start the chain saw. Doing so will put

the operator at risk of serious injury due to

loss of control of the chain saw.

IMPORTANT POINTS TO REMEMBER

When pulling the starter rope, do not use the

full extent of the rope as this can cause the

rope to break. Do not let starter rope snap

back. Hold the handle and let the rope re-

wind slowly.

For cold weather starting, start the unit at

FULL CHOKE; allow the engine to warm up

before squeezing the throttle trigger.

NOTE: Do not attempt to cut material with

the choke/fast idle lever in the FULL CHOKE

position.

HELPFUL TIP

If your engine still does not

start after following these

instructions, please call

1--800--554--6723.

STARTING A COLD ENGINE (or warm

engine aft er runni ng out of fuel)

NOTE:

In the following steps, when the

choke/fast idle lever is pulled out to the full

extent, the correct throttle setting for starting

is set automatically.

IGNITION

SWITCH

ON

STOP

Choke

Lever

1. Mo ve ON/STOP switch to th e ON posi-

tion.

2. Slowly press primer bulb 6 times.

3. Pull choke/fast idle lever out to the full

extent (to the FULL CHOKE position).

4. Pull the starter rope sharply 5 times with

your right hand. Then, proceed to the

next step.

NOTE: If the engine sounds as if it is trying

to start before the 5th pull, stop pulling and

immediately proceed to the next step.

5. Push the choke/fast idle lever in to the

HALF CHOKE position.

OFF

HALF

CHOKE/FAST IDLE LEVER

FULL

6. Pull the starter rope sharply with your

right hand until the engine starts.

7. Allow the engine to run for approximate-

ly 30 seconds. Then, squeeze and re-

lease the throttle trigger to allow engine

to return to idle speed.

STARTING A WARM ENGINE

1. Move ON/STOP switch to the ON posi-

tion.

2. Slowly press primer bulb 6 times.

3. To set the fast idle, pull the choke/fast

idle lever out to the full extent (to the full

choke position); then push the lever

back in to the HALF CHOKE position.

4. Pull the starter rope sharply with your

right hand until the engine starts.

5. Squeeze and release throttle trigger to

allow engine to return to idle speed.

DIFFICULT STARTING (or starting a

flooded engine)

The engine may be flooded with too much

fuel if it has not started after 10 pulls. Flooded

engines can be cleared of excess fuel by

pushing the choke/fast idle lever in com-

pletely (to the OFF CHOKE position) and

then following the warm engine starting pro-

cedure listed above. Ensure the ON/STOP

switch is in the ON position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Commentaires sur ces manuels

Pas de commentaire