Poulan 115153026 Manuel d'utilisateur télécharger pdf (Page 14)

14

LIMBI NG

S Always limb a tree after it is cut down. Only

then can limbing be done safely and prop-

erly.

S Leave the larger limbs underneath the felled

tree to support the tree as you work.

S Start at the base of the felled tree and work

toward the top, cutting branches and limbs.

Remove small limbs with one cut.

S Keep the tree between you and the chain.

Cut from the side of the tree opposite the

br a n ch you are cutt i n g .

S Remove larger , supporting branches with

the cutting techniques described in BUCK-

ING WITHOUT A SUPPOR T.

S Always use an overcut to cut small and free-

ly hanging limbs. Undercutting could cause

limbs to fall and pinch the saw .

PRUNING

WARNING: Limit pruning to limb s

shoulder height or below. Do not cut if

branches are higher than your shoulder . Get a

professional to do the job.

S Make your first cut

1/3 of the way through the

bottom of the limb.

S Next make a 2nd cut all the way through

the limb. Then cut a third overcut leaving a

1 to 2 inch (2.5 to 5 cm) collar from the truck

of the tree.

First cut

Second cut

Third cut

Collar

Pruning technique

SERVICE

WARNING: Disconnect the spark

plug before performing maintenance except

for carburetor adjustments.

We recommend all service and adjustments

not listed in this manual be performed by an

authorized or Master Service Dealer.

HELPFUL TIP

IMPORTANT: Have all

repairs other than the rec-

ommended maintenance

described in the instruction

manual performed by an

authorized service dealer.

If any dealer other than an authorized

service dealer performs work on the

product, Poulan may not pay for repairs

under warranty. It is your responsibility

to maintain and perform general mainte-

nance.

MAINTENANCE SCH E DULE

Check:

Fuel mixture level Before each use....

Bar lubrication Before each use.......

Chain tension Before each use.......

Chain sharpness Before each use.....

For damaged parts Before each use...

For loose caps Before each use......

For loose fasteners Before each use...

For loose parts Before each use......

Inspect and Clean:

Bar Before each use................

Complete saw After each use.......

Air filter Every 5 hours*.............

Chain brake Every 5 hours*.........

Spark arresting screen

and muffler Every 25 hours*..........

Replace spark plug Yearly.

Replace fuel filter Yearly...

* Hours of Operation --

Each hour of operation is approximately

2 tanks of fuel.

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover

items that have been subjected to operator

abuse or negligence. To receive full value

from the warranty, the operator must main-

tain unit as instructed in this manual. Various

adjustments will need to be made periodical-

ly to properly maintain your unit.

S Once a year , replace the spark plug, air filter ,

and check guide bar and chain for wear. A

new spark plug and air filter assures proper

air-fuel mixture and helps your engine run

better and last longer .

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for re-

placement of damaged or worn parts.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Commentaires sur ces manuels

Pas de commentaire