Poulan 193747 Manuel d'utilisateur télécharger pdf (Page 10)

10

ASSEMBLE UPSTOP

BRACKET

(SEE ILLUSTRATION ABOVE)

• Position upstop bracket over hole inside

the left side of upper handle and install

upstop bracket screw #10-24 x 1/2.

Tighten securely.

ASSEMBLE WHEELS

(USE HARDWARE GROUP “C”)

NOTE: Some model mowers do not have

bafﬂ es on underside of mower housing.

On models without bafﬂ e in front and/or

rear of housing, use the 1-1/4" washers

sup plied when you assemble the wheels.

MODELS WITH BOLT-ON WHEELS:

Cutting height is de ter mined by as sem -

bling wheels in one of four possible posi-

tions on the mower housing. All wheels

must be in the same height position for

even cut ting.

• For each wheel, assemble shoul der bolt,

wheel and spacer as shown.

• Assemble 1-1/4" diam. washer (if sup-

plied) and 3/8-16 lock nut on inside of

mower housing and tight en se cure ly.

(SIDE DISCHARGE MOWER SHOWN)

MODELS WITH "QUICK ADJUST"

WHEEL HEIGHT ADJUSTERS :

Look carefully at the four (4) adjuster

assemblies. Notice that there are two (2)

each of two (2) different types.

Spacer

Wheel

3/8-16

Locknut

1-1/4" diameter Washer

(Rear wheels only)

Mower housing

Shoulder

bolt

ASSEMBLE ADJUSTERS TO DECK

• Position appropriate adjuster at each

corner of mower.

• Install each adjuster with adjuster bolt

and tab in deck holes as shown and

secure with 1-1/4" diam. washer (if sup-

plied) and 3/8-16 locknut. Tight en all

adjusters se cure ly.

SIDE DISCHARGE MOWERS:

REAR DISCHARGE MOWERS:

ASSEMBLE WHEELS TO ADJUSTERS

• Secure each wheel with ﬂ at washer

and retainer spring or ﬂ ange locknut (if

equipped with threaded axle).

• Assemble adjustment knobs to ad just er

levers by press ing or tapping lightly.

• If your mower is equipped with hub caps,

install by pressing or tap ping lightly until

hub cap snaps se cure ly over ﬂ at wash er.

Wheel

Flat washer

Retainer

spring

Axle arm

Hubcap (If epuipped)

Flange locknut

(If equipped with

threaded axle arm)

Adjustment

knob

Type I is for the

Right Rear and Left

Front installation.

Type II is for the

Right Front and Left

Rear installation.

TYPE I

Right rear/left front

height ad just er

TYPE II

Right front/left rear height ad just er

Tab hole

Tab hole

1-1/4" Washer

(If supplied)

Locknuts

TYPE I

Right rear/left front

height ad just er

TYPE II

Right front/left rear height ad just er

Tab hole

Tab hole

1-1/4" Washer

(If supplied)

Locknuts

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire