Poulan 156235 Manuel d'utilisateur télécharger pdf (Page 7)

02352

REAR MOUNTING BRACKET and

SUPPORT TUBE

(See Figs. 1A, 1B & 1C)

Use Hardware - - GROUP "A"

Before continuing with assembly, you must ﬁ rst determine

which type of drawbar your tractor is equipped with. Com-

pare your drawbar with the illustrations of "BEFORE YOU

START TO AS SEM BLE THE GRASS CATCHER" and follow

instructions given.

DRAWBAR WITH UPPER CORNER RIBS - STYLE "A"

NOTE: If your tractor already has four (4) shoulder bolts

installed on the rear draw bar, simply hang the mounting

bracket, lanced tabs towards bottom, on the bolts (See

Fig. 1A).

1. Assemble the support tube to drawbar as shown. From

backside of drawbar place reinforcement plate so that

weld screws go through holes in left side of drawbar.

Place support tube over weld screws and assemble

ﬂ at washer, lockwasher, and wing nut as shown Do

not tighten at this time.

2. Discard remaining hardware in hardware GROUP

"A".

If your tractor does not have four (4) shoulder bolts in-

stalled on the drawbar, follow the instructions below (See

Fig. 1B).

1. Using the four formed holes in the drawbar, install the

four self tapping shoulder bolts as shown and tighten

securely.

2. Hang the mounting bracket, lanced tabs towards bottom,

on the bolts.

3. Assemble the support tube to drawbar as shown. From

backside of drawbar place reinforcement plate so that

weld screws go through holes in left side of drawbar.

Place support tube over weld screws and assemble

ﬂ at washer, lockwasher, and wing nut as shown Do

not tighten at this time.

4. Discard remaining hex bolts and locknuts in hardware

GROUP "A".

LANCED TABS

TOWARD BOTTOM

SHOULDER

BOLTS

FIG. 1A

DRAWBAR WITHOUT UPPER CORNER RIBS -

STY LE "B" (See Fig. 1C)

1. Assemble the mounting bracket, lanced tabs towards

bottom, using the four smaller inside holes on the

drawbar.

2. Install the four hex bolts and locknuts as shown and

tighten securely.

3. Assemble the support tube to drawbar as shown. From

backside of drawbar place reinforcement plate so that

weld screws go through holes in left side of drawbar.

Place support tube over weld screws and assemble

ﬂ at washer, lockwasher, and wing nut as shown Do

not tighten at this time.

4. Discard remaining shoulder bolts in hardware GROUP

"A".

UPPER

CORNER

RIBS

REINFORCEMENT

PLATE

SUPPORT TUBE

FLAT

WASHERS

LOCK

WASHERS

WING

NUTS

LANCED TABS

TOWARD BOTTOM

SELF TAPPING

SHOULDER

BOLTS

FIG. 1B

UPPER

CORNER

RIBS

REINFORCEMENT

PLATE

SUPPORT TUBE

FLAT

WASHERS

LOCK

WASHERS

WING

NUTS

02353

LANCED TABS

TOWARD BOTTOM

LOCKNUTS

FIG. 1C

HEX

BOLTS

REINFORCEMENT

PLATE

SUPPORT TUBE

FLAT

WASHERS

LOCK

WASHERS

WING

NUTS

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Commentaires sur ces manuels

Pas de commentaire

Poulan 156235 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Poulan 156235