Poulan PT7000 Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
SPARK ARRESTOR
This unit is not equipped with a
temperature limiting muffler and spark
arresting screen which meets the re
quirements of California Codes 4442
and 4443. All U.S. forest land and the
states of California, Idaho, Maine, Min
nesota, New Jersey, Oregon, and
Washington require by law that many
internal combustion engines to be
equipped with a spark arrestor screen.
If you operate in a locale where such
regulations exist, you are legally re
sponsible for installing and maintaining
the operating condition of these parts.
Failure to do so is a violation of the
law. If a spark arrestor is required in
your area, contact your Authorized
Service Dealer for the proper kit.
REPLACING THE LINE
Push and hold the engine stop switch
in the stop/off position until the unit has
fully stopped.
Disconnect the spark plug lead wire.
Remove spool by firmly pulling on tap
button.
Clean entire surface of hub and spool.
Replace with a pre-wound spool, or
cut two 12.5 foot (3.8 m) lengths of
.080" (2 mm) diameter Poulan® brand
line. Never use wire, rope, string, etc.,
which can break off and become a
dangerous missile.
Insert ends ofthe line about 1/2 inch (1
cm) into the small hole on the inside of
spool.
Hub
Line in Notch
• Wind the line evenly and tightly onto
the spool. Wind in the direction of the
arrows found on the spool.
Push the line into the notches, leaving
3 to 5 inches (7 - 12 cm) unwound.
Insert the line into the the exit holes in
the hub as shown in the illustration.
Align notches with the line exit hole.
Push the spool into the hub until it
snaps into place.
• Pull the line extending outside of the
hub to release it from the notch.
CLEAN UNIT & LABELS
Clean the unit using a damp cloth and a
mild detergent. Wipe off the unit with a
clean, dry cloth.
SPARK PLUG
Replace spark plug yearly with a Cham
pion CJ-8Y plug: spark plug gap is .025 in.
IGNITION TIMING
Ignition timing is fixed, non-adjustable.
CARBURETOR ADJUSTMENT
Your carburetor is equipped with limiter
caps. Damage will occur if you turn the
needles beyond the limiter caps. Carbure
tor adjustment is a complicated task. We
recommend that you take your unit to an
Authorized Service Dealer.
NEED ASSISTANCE?
Call 1 -800-554-6723 for assistance.
Need Service Parts?
Contact your dealer or call 1-800-554-6723.
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire