Poulan 163661 Manuel d'utilisateur télécharger pdf (Page 12)

OPERATION

CULTIVATING

Cultivating is destroying the weeds between rows to pre

vent them from robbing nourishment and moisture from the

plants. At the same time, breaking up the upper layer of soil

crust will help retain moisture In the soil. Best digging depth

is 1" to 3” {2.5-7.5 cm). Lower the outer side shields to

protect small plants from being buried.

» Cultivate up and down the rows at a speed which will

allow tines to uproot weeds and leave the ground in

rough condition, promoting no further growth of weeds

and grass (See Fig. 15).

ADJUST WHEELS FOR CULTIVATING (See

Figs. 16 and 17)

* Piace blocks under right hand side of tiller and remove

hairpin clip and clevis pin from right hand wheel.

® Move wheel outward approximately 1 inch (2.5 cm)

until hole in inner wheel hub lines up with inner hole in

axle.

• Replace clevis pin and hairpin clip on inside of wheel

and remove biocks.

» Repeat preceding steps on left hand side.

NOTE: Inextremeiy roughconditionsandwhilecultivating,

the wheels should be moved outward on the axle for

increased stability.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Poulan 163661 Manuel d'utilisateur Page 12