Poulan 163661 Manuel d'utilisateur télécharger pdf (Page 17)

SERVICE AND ADJUSTMENTS

TO REMOVE BELT GUARD (See Fig= 27)

NOTE: For ease of removal, remove hairpin clip and clevis

pin from left wheel. Pull wheel out from tiller about 1 inch

(2,5 cm).

* Remove two (2) cap nuts and washers from side of belt

guard.

« Remove hex nut and washer from bottom of belt guard

(located behind wheel).

» Pull belt guard out and away from unit.

® Replace belt guard by reversing above procedure.

TO REPLACE GROUND DRIVE BELT (See

Figs. 27 and 28)

9 Move left wheel and remove belt guard as described in

‘TO REMOVE BELT GUARD*’.

» Loosen belt guides “A” and “B” and also nuts “C” and

“D”.

« Remove old belt by slipping from engine pulley first.

9 Place new belt in groove of transmission pulley and

into engine pulley. BELT MUST BE IN GROOVE ON

TOP OF IDLER PULLEY. NOTE POSITION OF BELT

TO GUIDES.

» Tighten belt guides “A” and “B” and nuts “C” and “D”.

» Check belt adjustment as described below.

* Replace belt guard.

® Reposition wheel and replace clevis pin and hairpin

clip.

GROUND DRIVE BELT ADJUSTMENT (See

Fig. 25)

For proper belt tension, the extension spring should have

about 5/8 inch (16 mm) stretch when drive control bar is in

“ENGAGED” position. This tension can be attained as

follows:

9 Loosen cable clip screw securing the drive control

cable.

9 Slide cable forward for less tension and rearward for

more tension until about 5/8 inch (16 mm) stretch is

obtained while the drive control bar is engaged.

9 Tighten cable clip screw securely.

FIG. 28

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Pas de commentaire

Poulan 163661 Manuel d'utilisateur Page 17