Poulan PP135 Manuel d'utilisateur télécharger pdf (Page 11)

11

S

Tap the bottom of the trimmer head lightly on

the ground one time. Approximately 2 inches

(5 cm) of line will be advanced with each tap.

Always tap the trimmer head on a grassy

area. Tapping on surfaces such as concrete

or asphalt can cause excessive wear to the

trimmer head.

If the line is worn down to 2 in. (5 cm) or less,

more than one tap will be required to obtain

the most efficient line length.

WARNING:

Use only 0.080” (2 mm)

diameter line. Other sizes of line will not ad-

vance properly and can cause serious injury.

Do not use other materials such as wire,

string, rope, etc. Wire can break off during

cutting and become a dangerous missile that

can cause serious injury.

CUTTING METHODS

WARNING:

Use minimum speed

and do not crowd the line when cutting around

hard objects (rock, gravel, fence posts, etc.),

which can damage the trimmer head, become

entangled in the line, or be thrown causing a

serious hazard.

S

The tip of the line does the cutting. You will

achieve the best performance and

minimum line wear by not crowding the line

into the cutting area. The right and wrong

ways are shown below.

Tip of the Line

Does The Cutting

Right

Line Crowded Into

Work Area

Wrong

S

The line will easily remove grass and

weeds from around walls, fences, trees and

flower beds, but it also can cut the tender

bark of trees or shrubs and scar fences.

S

For trimming or scalping, use less than full

throttle to increase line life and decrease head

wear, especially:

S

Dur ing light duty cutting.

S

Near objects around which the line can

wrap such as small posts, trees or fence

wire.

S

For mowing or sweeping, use full throttle for

a good clean job.

TRIMMING

-- Hold the bottom of the trimmer

head about 3 in. (8 cm) above the ground and

at an angle. Allow only the tip of the line to

make contact. Do not force trimmer line into

work area.

Trimming

3in.(8cm)

Above Ground

SCALPING

-- The scalping technique re-

moves unwanted vegetation down to the

ground. Hold the bottom of the trimmer head

about 3 in. (8 cm) above the ground and at an

angle. Allow the tip of the line to strike the

ground around trees, posts, monuments, etc.

This technique increases line wear.

Scalping

MOWING

-- Your trimmer is ideal for mowing

in places conventional lawn mowers cannot

reach. In the mowing position, keep the line

parallel to the ground. Avoid pressing the

head into the ground as this can scalp the

ground and damage the tool.

Mowing

SWEEPING

-- The fanning action of the rotat-

ing line can be used for a quick and easy

clean up. Keep the line parallel to and above

the surfaces being swept and move the tool

from side to side.

Sweeping

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire