Poulan 159515 Manuel d'utilisateur télécharger pdf (Page 12)

ie operai

suit in Sí

îur tracte

lt6t¥ ÏTI3S

iny irdcior Cdïl resi

/e damage. Always

perform ir

'er the spe

nv adju

HOW ■ < 4- ' Hlr I'

TO lT i i '•Ohllti ^ H ■ f e ' 'fj. c|

hour cat ic'S ( (J''u* Ml. HIM i .r j (est nc e censini;

swilch \/'hi-n -fiC's iiihMTK) iv i'lPinpi hv 'tie

opcrcioiu itM' I ' . M '] ! u.i oMiiiiii ih' par'iing

brake will hui . . ' f f. 'jnu

Depia s.luu i> l l.< irn j nl' f P/M~ ’ f-i'

ana noici.

• Place parking brake lever in “ENGAGE:D”j:)Osition and

release pressure from clutch/brake pedal. Pedal should

remain in “BRAKE” position. Make sure parking brake

will hold tractor secure.

THROTTLE

CONTRO!.

CLUTCH/

BRAKE

PEDAL

“DRIVE”-

POSITION

A I TAi HIUkrt r CLUTCH LEVER

FNG/,GEL POSITION

“DISENGAGED”

POSITION

PARKING

BRAKE

“ENGAGED”

POSITION

GEARSHIFT LEVER

\ DISENGAGED”

.'OSITION

FIG. 6

STOPPING (See Fig. 6j

MOWER BLADES ■

• Move attachment clutch lever to “DISENGAGED” po

sition.

GROUND DRIVE -

• Depress clutch/brake pedal into full “BRAKE” position.

• Move motion control lever to neutral (N) position.

IMPORTANT: THE MOTION CONTROL LEVER DOES

NOT RETURN TO NEUTRAL (N) POSITION WHEN THE

CLUTCH/BRAKE PEDAL IS DEPRESSED,

ENGINE -

• Move throttle control to slow i -^) position.

NOTE: Failure to move throttle control to slow c^)

position and allowing engine to idle before stopping may

cause engine to “backfire”

• Turn ignition key to “OFT” position and remove key.

Always remove key when leaving tractor to prevent

unauthorized use.

• Never use choke to stop engine.

NOTE: Under certain conditions when tractor is standing

idle with the engine running, hot engine exhaust gases may

cause “browning” of grass. To eliminate this possibility,

always stop engine when stopping tractor on grass areas.

it in foreign objects

wear safety glass«

Affi ^ il •• i

tandard safety qla.

ye sriie

recomr

while operating

d a wide vision

'“'I; Always stop tractor coiri“ |

s described above, before ieav-

operator's positioii; to empty

tcher, etc»

TO?- i row ■ r^Thr," of TDeeFig. 6)

Aiwa/,. , M M u ig ii i1 ili ih o ill

® Operating engine at less than full throttle reduces the

battery charging rate.

• Full throttle offers the best bagging and mower perfor

mance.

TO USE CHOKE CONTROL (See Fig. 6)

Use choke control whenever you are starting a cold engine.

Do not use to start a warm engine.

® To engage choke control, pull knob out. Slowly push

knob in to disengage.

TO MOVE r IRWaRO T f^D BACKWARD (See

Fig. 6)

The direction and speed of movement is controlled by the

motion control lever.

• Start tractor with motion control lever in neutral (N)

position.

• Release parking brake and clutch/brake pedal.

• Slowly move motion control lever to desired position.

TO ADJUST MOWER CUTTING HEIGHT (See

Fig. 6)

The cutting height is controlled by turning the height

adjustment knob in desired direction.

• Turn knob clockwise (“ t) to raise cutting height.

• Turn knob counterclockwise (AT) to lower cutting

height.

The cutting height range is approximately 1-1/2" to 4". The

heights are measured from the ground to the blade tip with

the engine not running. These heights are approximate

and may vary depending upon soil conditions, height of

grass and types of grass being mowed.

• The average lawn should be cut to approximately 2-

1/2 inches during the cool season and to over 3 inches

during hot months. For healthier and better looking

lawns, mow often and after moderate growth.

• For best cutting performance, grass over 6 inches m

height should be mowed twice. Make the first cut

relatively high; the second to desired height.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Poulan 159515 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Poulan 159515