Poulan 530163467 Manuel d'utilisateur télécharger pdf (Page 6)

6

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE: If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

TOOLS REQUIRED

S Hex wrench (provided)

INSTALL ING PRUNER ATTACH-

MENT

CAUTION:

When removing or installing at-

tachments, place the unit on a flat surface for

stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Coupler

Knob

LOOSEN

TIGHTEN

2. Remove the shaft cap from the pruner at-

tachment (if present).

3. Position locking/release button of attach-

ment into guide recess of coupler.

4. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

5. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler Primary Hole

Upper

Shaft

Locking/

Release

Button

Lower

Attachment

Guide Recess

WARNING: Make sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit.

SHOULDER STRAP ASSEMBLY

WARNING: Proper shoulder strap and

handle adjustments are required before use.

The shoulder strap clamp must be installed as

shown above the assist handle on the upper

shaft (powerhead end of unit).

NOTE: The lower shoulder strap clamp has

two spacer tabs attached. These tabs are

provided to adapt this attachment for use with

powerheads that have a 1″ diameter upper

shaft (the shoulder strap clamp will not tighten

down securely on the 1″ diameter upper shaft

without using these spacer tabs). The tabs

must be broken off completely before use and

placed over the screw holes on the lower

shoulder strap clamp. These tabs are not

needed for powerheads with a 7/8″ upper

shaft.

Spacer Tabs

LOWER S HOUL DER STRAP

CLAMP

Spacer Tabs

positioned for use

on 1″ diameter

upper shaft

1. Place the upper shoulder strap clamp

over the upper shaft above the handlebar.

2. Position the lower shoulder strap clamp

under the upper shaft and align the upper

and lower clamp screw holes (use spacer

tabs between upper and lower clamps if

necessary to secure clamp, i.e. for 1″ di-

ameter upper shaft).

Upper Shoulder

Strap Clamp

Screws

Lower Shoulder

Strap Clamp

POWERHEAD

END

ATTACHMENT

END

3. Insert two screws into the screw holes.

4. Secure shoulder strap clamp by tighten-

ing screws with the hex wrench.

5. T ry on shoulder strap and adjust for fit and

balance before starting the eng ine or begin-

ning a cutting operation.

6. Insert your right arm and head through the

shoulder strap and allow it to rest on your

left shoulder. Make sure the danger sign

is on your back and the hook is to the right

side of your waist.

NOTE: A one-half twist is built in the shoul-

der strap to allow the strap to rest flat on the

shoulder.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire