Poulan 545123649 Manuel d'utilisateur télécharger pdf (Page 6)

6

damage in otherwise healthy people. If

symptoms occur such as numbness, pain,

loss of strength, change in skin color or texture,

or loss of feeling in the fingers, hands, or joints,

discontinue the use of this tool and seek

medical attention. An anti-vibration system

does not guarantee the avoidance of these

problems. Users who operate power tools on

a continual and regular basis must monitor

closely their physical condition and the

condition of this tool.

SPECIAL NOT ICE: Your saw is equipped

with a temperature limiting muffler and spark

arresting screen which meets the

requirements of California Codes 4442 and

4443. All U.S. forest land and the states of

California, Idaho, Maine, Minnesota, New

Jersey, Oregon, and Washington require by

law that many internal combustion engines

to be equipped with a spark arresting screen.

If you operate a chain saw in a state or locale

where such regulations exist, you are legally

responsible for maintaining the operating

condition of these parts. Failure to do so is

a violation of the law. Refer to the SERVICE

section for m aintenance of the spark

arresting screen.

Failure to follow all Safety Rules and Precau-

tions can result in serious injury. If situations

occur which are not covered in this manual,

use care and good judgement. If you need

assistance, contact your authorized service

dealer or call 1-800--554--6723.

STANDARDS: This saw is listed by Under-

writer’s Laboratories, Inc., and the Canadian

Standards Association in accordance with:

ANSI B175.1-2000 American National

Standard for Powered Tools -- Gasoline

Powered Chain Saw -- Safety Requirements

CSA Z62.1--03 Chain Saws -- Occupational

Health and Safety

CSA Z62.3--96 Chain Saw Kickback Occu-

pational Health and Safety

ASSEMBLY

Protective gloves (not provided) should be

worn during assembly.

ATTACH ING THE BAR & C HAIN (If not

already attached)

WARNING: If re ceived assembled,

repeat all steps to ensure your saw is properly

assembled and all fasteners are secure. Al-

ways wear gloves when handling the chain.

The chain is sharp and can cut you even when

it is not moving!

1. Loosen and remove the chain brake nuts

and the chain brake from the saw.

2. Remove the plastic shipping spacer (if

present).

Chain Brake

Chain Brake

Nuts

Bar Tool

Location of shipping spacer

3. An adjusting pin and screw is used to ad-

just the tension of the chain. It is very im-

portant when assembling the bar , that the

pin located on the adjusting screw aligns

into a hole in the bar . T urnin g the screw will

move the adjustment pin up and down the

screw. Locate this adjustment before you

begin mounting the bar onto the saw . See

illustration below .

Adjustment located on Chain Brake

Inside view of

Chain Brake

4. Turn the adjusting screw by hand coun-

terclockwise until the adjusting pin just

touches the stop. This should allow the

pin to be near the correct position.

5. Slide guide bar behind clutch drum until

guide bar stops against clutch drum

sprocket.

Mount the Bar

6. Carefully remove the chain from the pack-

age. Hold chain with the drive links as

sho wn .

CUTTERS MUST FACE IN

DIIRECTION OF ROTATION

Tip of

Bar

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Commentaires sur ces manuels

Pas de commentaire