Poulan P3500 Manuel d'utilisateur télécharger pdf (Page 7)

7

Choke

Lever

Starter Handle

Primer Bulb

5. Pull starter rope handle sharply until engine

sounds as if it is trying to start, but do not

pull rope more than 6 times.

6. As soon as engine sounds as if it is trying to

start, move choke lever to HALF CHOKE

position.

7. Pull starter rope sharply until engine runs,

but no more than 6 pulls.

NOTE: If the engine doesn’t start after 6

pulls (at the HALF CHOKE position),

move the choke lever to the FULL

CHOKE position and press the primer

bulb 6 times. Squeeze and hold the

throttle trigger and pull the starter rope 2

more times. Move the choke lever to the

HALF CHOKE position and pull the start-

er rope until the engine runs, but no more

than 6 pulls. If the engine still doesn’t

start, it is probably flooded. Proceed to

STARTING A FLOODED ENGINE.

8. Once the engine starts, allow it to run 10 se-

conds, then move the choke lever to the

RUN position. Allow the unit to run for 30

more seconds at RUN before releasing the

throttle trigger .

NOTE: If engine dies with the choke le-

ver in the RUN position, move the choke

lever to the HALF CHOKE position and

pull the rope until engine runs, but no

more than 6 pulls.

STARTING A WARM ENGINE

1. Move the choke lever to the HALF CHOKE

position.

2. Squeeze and hold the throttle trigger . Keep

throttle trigger fully squeezed until the en-

gine runs smoothly.

3. Pull starter rope sharply until engine runs,

but no more than 6 pulls.

4. Allow engine to run 15 seconds, then move

thechokelevertoRUN.

NOTE: If engine has not started, pull starter

rope 5 more pulls. If engine still does not run, it

is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing

the choke lever in the RUN position; then, pull

the rope to clear the engine of excess fuel.

This could require pulling the starter handle

many times depending on how badly the unit

is flooded.

If the unit still doesn’t start, refer to

TROUBLESHOOTING TABLE or call

1-800-554-6723.

OPERATING INSTRUCTIONS

It is recommended that the engine not be

operated for longer than 1 minute at full

throttle.

OPERATING POSITION

Cut from your right to your left.

ALWAYS WEAR:

Eye protection

Long pants

Heavy shoes

WARNING: Always wear eye protec-

tion. Never lean over the trimmer head.

Rocks or debris can ricochet or be thrown into

eyes and face and cause blindness or other

serious injury.

Do not run the engine at a higher speed than

necessary. The cutting line will cut efficiently

when the engine is run at less than full throttle.

At lower speeds, there is less engine noise and

vibration. The cutting line will last longer and will

be less likely to “weld” onto the spool.

Always release the throttle trigger and allow the

engine to return to idle speed when not cutting.

To stop engine:

S Release the throttle trigger.

S Push and hold the STOP switch in the

STOP position until the engine stops.

TWIST AND EDGE

The Twist and Edge feature allows for easy

edging of sidewalks, patios, driveways, etc.

1. Pull the tab toward the engine.

2. Twist the shaft to the edging position; re-

lease tab.

Tab

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire