Poulan 139700 Manuel d'utilisateur télécharger pdf (Page 13)

OPERATION

TO OPERATE MOWER (See Figs. 10 and 11)

Your unit is equipped with an operator presence sensing

switch. Any attempt by the operator to leave the seat with

the engine running and the mower clutch engaged will shut

off the engine.

• Select desired height of cut.

• Lower mower with attachment lift control.

• Start mower blades by engaging attachment clutch

control.

• TO STOP MOWER BLADES - disengage attachment

clutch control.

CAUTION: Do not operate the mower

without either the entire grass catcher, on

mowers so equipped, or the discharge

guard in place.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down

hills with slopes greater than 15° and

do not drive across any slope.

Choose the slowest speed before starting up or down

hills.

Avoid stopping or changing speed on hills.

If slowing is necessary, move throttle control to slower

position.

if stopping is absolutely necessary, push clutch/brake

pedal quickly to brake position and engage parking

brake.

Move gearshift lever to “NEUTRAL" position.

T0 restart movement, move gearshift lever to 1 st gear.

Be sure you have allowed room for tractor to roll slightly

as you restart movement.

Slowly release parking brake and clutch/brake pedal.

Make all turns slowly.

TO TRANSPORT

• Raise attachment lift control to highest position.

• When pushing or towing your tractor, be sure gearshift

lever is in “NEUTRAL” position.

• Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting

yourtractor on a truck or a trailer, be sure hood is closed and

secured to tractor. Use an appropriate means of tying hood

to tractor (rope, cord, etc.).

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL (See Fig. 13)

• The engine in your unit has been shipped, from the

factory, already filled with summer weight oil.

• Check engine oil with unit on level ground.

• Remove oil fill cap/dipstick and wipe clean, reinsert the

dipstick and screw cap tight, wait for a few seconds,

remove and read oil level. If necessary, add oil until

“FULL” mark on dipstick is reached. Do not overfill.

• For cold weather operation you should change oil for

easier starting (See “OIL VISCOSITY CHART” in the

Customer Responsibilities section of this manual).

• To change engine oil, see the Customer Responsibili

ties section in this manual.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Poulan 139700 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Poulan 139700