Poulan 530088812 Manuel d'utilisateur télécharger pdf (Page 5)

-- 5 --

BEFORE STARTING THE ENGINE

WARNING:

Try on the unit and adjust

the shoulder straps for fit and comfort

before

starting the engine to avoid losing control of

the unit. Always start and run the unit in an up-

right position.

Fuel engine. Move at least 10 feet (3 me-

ters) away from the fueling site.

Hold the unit in the starting position as

shown. Make sure the blower end is di-

rected away from people, animals, glass,

and solid objects.

STARTING POSITION

WARNING:

When starting engine,

hold the unit as illustra ted . Do not set unit on any

surface except a clean, hard area when starting

engine or while engine is running. Debris such

as gravel, sand, dust, grass, etc. could be

picked up by the air intake and thrown out

through the discharge opening, damaging the

unit or property, or causing serious injury to by-

standers or the operator.

WARNING:

Avoid contact with the

muffler. A hot muffler can cause serious

burns.

STARTING A COLD ENGINE (or warm

engine that has run out of fuel)

Press the primer bulb (located under the

carburetor) until fuel can be seen flowing

through the fuel return line.

Move the choke lever to the CLOSED posi-

tion.

Move the START/STOP switch to START.

Fuel

Return

Line

Choke Lever

Primer

Bulb

Muffler

Set the throttle lever at HALF speed (see

ASSEMBLY section for illustration of

throttle lever).

Pull starter rope sharply until engine runs.

NOTE:

Only short pulls are necessary. Nev-

er pull the starter cord to its fullest extension.

Never let go of the starter grip until it is at the

fully returned position.

Once the engine has started, slowly move

the choke lever to the OPEN position.

Allow the unit to warm up at less than HALF

speed.

STARTING A WARM ENGINE

Move the choke lever to the OPEN position.

Set the throttle lever at HALF speed.

Pull starter rope sharply until engine runs.

DIFFICULT STARTING (or starting a

flooded engine)

Move the choke lever to the OPEN position

Set the throttle lever at HALF speed.

Pull rope to clear engine of excess fuel.

This could require pulling the starter rope

many times.

If unit still doesn’t start, contact your authorized

service dealer.

BLOWER OPERATION

When the engine has warmed up, the blower

can be positioned on the back of the operator.

Once the blower is positioned and ready for

operation, adjust the throttle to a speed re-

quired to accomplish the task.

NOTE:

Always run the engine at idle speed

for a few minutes to allow cooling before stop-

ping the engine.

SERVICE

We recommend all service and adjustments

not listed in this manual be performed by an

Authorized Service Dealer.

CARBURETOR ADJUSTMENTS

Your carburetor is equipped with limiter caps.

Carburetor adjustment is a complicated task.

We recommend that you take your unit to an

Authorized Service Dealer. Damage may occur

if you turn the needles beyond the limiter stops.

IGNITION TIMING

Ignition timing is fixed, non-adjustable.

SPARK PLUG

Replace the spark plug yearly using a Cham-

pion RCJ--7Y plug. Spark plug gap is .025”.

AIR FILTER

CAUTION:

Do not clean filter in gasoline or

other flammable solvent to avoid creating a

fire hazard or producing harmful evaporative

emissions

A dirty air filter decreases engine perfor-

mance and increases fuel consumption and

harmful emissions. Always inspect the air fil-

ter each time you use the blower (more often

in extreme conditions) by removing the air fil-

ter cover.

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Poulan 530088812 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs et séchoirs à air Poulan 530088812