Poulan PPB5500P Manuel d'utilisateur télécharger pdf (Page 7)

7

6. Before using the unit, tighten both knobs

securely by turning clockwise.

WARNING: Make sure the locking/

release button is locked in the primary hole of

both couplers and the knobs are securely

tightened before operating the unit. Using the

wrong holes could lead to serious injury or dam-

age to the unit.

Locking/Release

Button in Primary Hole

SHOULDER STRAP ASSEMBLY

WARNING: Proper shoulder strap and

handle adjustments are required before use.

The shoulder strap clamp must be installed as

shown above the assist handle on the engine

end shaft.

NOTE: The lower shoulder strap clamp has

two spacer tabs attached. These tabs are

provided to adapt this attachment for use with

units that have a 1 inch (2,5 cm) diameter

shaft (the shoulder strap clamp will not tighten

down securely on the 1 inch (2,5 cm) diameter

shaft without using these spacer tabs). The

tabs must be broken of f completely before

use and placed over the screw holes on the

lower shoulder strap clamp. These tabs are

not needed for units with a 7/8″ (2,2 cm) shaft.

Spacer Tabs

LOWER SHOULDER STRAP

CLAMP

Spacer Tabs

positioned for use

on 1 inch (2,5 cm)

diameter shaft

1. Place the upper shoulder strap clamp

over the shaft above the assist handle.

2. Position the lower shoulder strap clamp

under the upper shaft and align the upper

and lower clamp screw holes (use spacer

tabs between upper and lower clamps if

necessary to secure clamp, i.e. for 1 inch

(2,5 cm) diameter shaft).

Upper Shoulder

Strap Clamp

Screws

Lower Shoulder

Strap Clamp

ENGINE/MOTOR

END

ATTACHMENT

END

3. Insert two screws into the screw holes.

4. Secure shoulder strap clamp by tighten-

ing screws with the hex wrench.

5. Try on shoulder strap and adjust for fit and

balance before starting the engine or begin-

ning a cutting operation.

6. Insert your right arm and head through the

shoulder strap and allow it to rest on your

left shoulder. Make sure the danger sign

is on your back and the hook is to the right

side of your waist.

NOTE: A one-half twist is built in the shoul-

der strap to allow the strap to rest flat on the

shoulder.

7. Adjust the strap, allowing the hook to be

about 3 -- 6 inches (8 -- 15 cm) below the

wai st.

8. Fasten the strap hook to the upper clamp

and lift the tool to the operating position.

Shoulder Strap

Shoulder

Strap

Clamp

ADJUSTING THE ASSIST HANDLE

WARNING: When adjusting the as-

sist handle, be sure it remains directly above

the coupler on the engine end shaft to ensure

proper balancing of unit.

Assist Handle

Coupler

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire