Poulan 545137280 Manuel d'utilisateur télécharger pdf (Page 9)

NOTE: A one-half twist is built in the shoul-

der strap to allow the strap to rest flat on the

shoulder.

3. Adjust the strap, allowing the hook to be

about 3 -- 6 inches (8 -- 15 cm) below the

wai st.

4. Fasten the strap hook to the clamp lo-

cated between the throttle handle and the

assist handle and lift the tool to the oper-

ating position.

NOTE: It may be necessary to relocate the

shoulder strap clamp on the shaft for proper

balancing of unit.

TO RELOCATE SHOULDER STRAP

CLAMP:

1. Loosen and remove both clamp screws.

2. Place the upper shoulder strap clamp

over the upper shaft.

3. Position the lower shoulder strap clamp

under the upper shaft and align the upper

and lower clamp screw holes.

Upper Shoulder

Strap Clamp

Screws

Lower Shoulder

Strap Clamp

POWERHEAD

END

ATTACHMENT

END

4. Insert two screws into the screw holes.

5. Secure shoulder strap clamp by tighten-

ing screws with a hex wrench.

ADJUSTING THE ASSIST HANDLE

WARNING: When adjusting the as-

sist handle, be sure it remains between the

coupler and the

lower arrow (closest to

coupler) on the safety label to ensure proper

balancing of unit. When adjusting the assist

handle or handlebar during use of optional at-

tachments, it must be repositioned between

the throttle trigger and the

upper arrow

(closest to engine) on the safety label.

1. Loosen wing nut on handle.

2. Rotate the handle on the shaft to an up-

right position; retighten wing nut.

ATTACHING SHIELD (FOR LINE

TRIMMER ATTACHMENT)

WARNING: The shield must be prop-

erly installed. The shield provides partial protec-

tion from the risk of thrown objects to the opera-

tor and others and is equipped with a line limiter

blade which cuts excess line to the proper

length. The line limiter blade (on underside of

shield) is sharp and can cut you. For proper

orientatio n of shield, see KNOW YOUR TRIM-

MER illustration in OPERA TION section.

1. Remove wing nut from shield.

2. Insert bracket into slot as shown.

3. Pivot shield until bolt passes through hole

in bracket.

4. Securely tighten wing nut onto bolt.

Slot

Shield

Wing

Nut

Bracket

Line Limiter Blade

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Poulan 545137280 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Poulan 545137280