Poulan 545137280 Manuel d'utilisateur télécharger pdf (Page 17)

17

TO REPLACE CHAIN:

1. Move ON/OFF switch to the OFF position

and disconnect spark plug.

2. Remove bar clamp nut.

3. Remove bar clamp.

4. Turn adjusting screw by hand counter-

clockwise until adjusting pin just touches

the stop.

5. Slide guide bar behind sprocket until

guide bar stops against sprocket.

6. Remove the old chain.

7. Carefully remove new chain from pack-

age. Hold chain with the drive links as

shown.

CUTTERS MUST FACE IN

DIRECTION OF ROTATION

Tip of

Bar

Cutter

Drivelink

Cutters

Depth Gauge

Drive Links

8. Place chain over sprocket, fitting the

drive links in the sprocket.

9. Fit bottom of drive links between the teeth

in the sprocket in the nose of the guide

bar.

10. Fit chain drive links into bar groove.

11. Pull guide bar forward until chain is snug

in guide bar groove. Ensure all drive links

are in the bar groove.

12. Now, install bar clamp making sure the

adjusting pin is positioned in the lower

hole in the guide bar.

Adjusting Pin

Lower

Hole

Guide Bar

13. Install bar clamp nut and finger tighten

only . Do not tighten any further at this

point. Proceed to the CHAIN ADJUST-

MENT section.

CHAIN ADJUSTMENT

See CHECK CHAIN TENSION in MAINTE-

NANCE section.

REPLACING T HE LINE

1. Remove spool by firmly pulling on tap

button.

2. Clean entire surface of hub and spool.

3. Replace with a pre-wound spool, or cut two

lengths of

12-1/2 feet of 0.080″ (2 mm) di-

ameter Poulan PRO brand line.

WARNING: Never use wire, rope,

string, etc., which can break off and become a

dangerous missile.

4. Insert ends of the lines about 1/2 inch (1

cm) into the small holes on the inside of

spool.

Small

Holes

Spool

H

u

b

Line in Notch

L

i

n

e

i

n

N

o

t

c

h

L

ine e

x

it holes

5. Wind the line evenly and tightly onto the

spool. Wind in the direction of the arrows

found on the spool.

6. Push the lines into the notches, leaving 3

to 5 inches (7 -- 12 cm) unwound.

7. Insert the lines into the the exit holes in

the hub as shown in the illustration.

8. Align the notches with the line exit holes.

9. Push spool into hub until it snaps into place.

10. Pull the lines extending outside of the hub

to release the lines from the notches.

1 2 ... 12 13 14 15 16 17 18 19 20 21

Commentaires sur ces manuels

Pas de commentaire