Poulan 530164264 Manuel d'utilisateur télécharger pdf (Page 7)

7

ASSEMBLY INFORMATION -- WEED

BLADE

WEED

BLADE

NOTE: Remove the trimmer head and plastic

shield before attaching the metal shield and

installing the weed blade. To remove the trimmer

head, align hole in the dust cup with the hole in

the side of the gearbox by rotating the dust cup.

Insert a small screwdriver into aligned holes.

This will keep the shaft from turning while loos-

ening the trimmer head. Remove the trimmer

head by turning clockwise. Remove the screw-

driver . To remove the plastic shield, loosen and

remove wing nut. Pivot shield to release bracket

from slot. See INST ALLA TION OF THE TRIM-

MER HEAD and A TTACHING THE PLASTIC

SHIELD for illustrations. Be sure to store all

parts and instructions for future use. Never use

the trimmer head with the metal blade installed.

ATTACHING T HE META L SHIELD

WARNING: The metal shield must be

properly installed on the tool anytime the tool

is used with a blade. The forward tip of the

metal shield helps to reduce the occurrence of

blade thrust which can cause serious injury

such as amputation to the operator or by-

standers. Failure to install the shield in the

position shown can result in serious injury to

the operator. The length of the shield must be

aligned with the length of the shaft.

1. Place the metal shield under the gearbox,

and align the screw holes.

Shield

Gearbox

2. Insert and thread the 4 mounting screws

through the holes of the gearbox and the

metal shield. Tighten evenly and secure-

ly with the hex wrench provided.

INSTALLATION OF THE METAL

BLADE

WARNING: W ear protective gloves

when handling or performing maintenance on

the blade to avoid injury. The blade is sharp

and can cut you even when it is not moving.

WARNING: Do not use any blades, or

fastening hardware other than the washers and

nuts shown in the following illustrations. These

parts must be provided by Poulan/Weed Eater

and installed as shown below. Failure to use

proper parts can cause the blade to fly off and

seriously hurt you or others.

NOTE: The dust cup and retaining washer are

located on the gearbox shaft and not in the parts

bag. All other fasteners mentioned in the follow-

ing assembly steps are in the parts bag.

1. Remove the retaining washer from the

threaded shaft of the gearbox. Leave the

dust cup on the shaft.

2. Install the blade and the retaining washer

over the threaded shaft.

3. Make sure the raised part of the retaining

washer is facing the gearbox and the raised

area fits into the hole in the center of the

blade.

4. Slide the blade and retaining washer onto

the shaft of the gearbox.

5. Place the cupped washer onto the shaft.

Make sure the cupped side of the washer

is toward the blade.

6. Install the blade nut by threading onto the

shaft counterclockwise.

Shield

Blade

Retaining

Washer

Dust Cup

Cupped

Washer

Nut

Threaded Shaft

Gearbox

NOTE: Make sure all parts are in place as il lus-

trated, and the blade is sandwiched between the

dust cup and the retaining washer . There should

be no space between the blade and the dust cup

or the retaining washer .

7. Align hole in dust cup with hole in side of

gearbox by rotating the blade.

8. Insert a small screwdriver into aligned

holes. This will keep the shaft from turn-

ing while tightening the blade nut.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire