Poulan 530164264 Manuel d'utilisateur télécharger pdf (Page 6)

6

30 inches

(76 cm)

HARNESS

ADJUSTMENT

FOR BALANCE

6 inches

(15 cm)

below

waist

4--12

inches

(10 -- 30 cm)

above

ground

30 inches

(76 cm)

CONFIGURING YOUR UNIT

You can configure your unit using a trimmer

head for grass and light weeds, or a weed blade

for cutting grass, weeds, and brush up to 1/2

inch (1 cm) in diameter. To assemble your unit,

go to the section for the desired configuration

and follow the instructions.

ASSEMBLY INFORMATION --

TRIMMER HEAD

TRIMMER

HEAD

NOTE: Remove the blade and metal shield be-

fore attaching the plastic shield and trimmer

head. To remove bla de, align hole in the dust

cup with the hole in the side of the gearbox by

rotating the blade. Insert a small screwdriver

into aligned holes. This wil l keep the shaft fr om

turning while loosening the blade nut. Remove

blade nut by turning clockwise. Remove the

screwdriver . Remove both washers and blade .

To remove metal shield, loosen and remove the

four mounting screws. See A TT ACHING THE

MET AL SHIELD and INSTALLA TION OF THE

MET AL BLADE for illustrations. Be sure to store

all parts and instructions for future use.

INSTALLATION OF THE TRIMMER

HEAD

NOTE:

Before installing the trimmer head,

make sure the dust cup and retaining washer

are positioned on the shaft of the gearbox.

The retaining washer must be positioned with

the raised section toward the gearbox.

1. Align hole in the dust cup with the hole in the

side of the gearbox by rotating the dust cup.

2. Insert a small screwdriver into aligned

holes. This will keep the shaft from turn-

ing while tightening trimmer head.

Screwdriver

3. While holding the screwdriver in position,

thread trimmer head onto the shaft by turn-

ing counterclockwise. Tighten until secure.

Trimmer

head

Dust cup

Gearbox

Retaining

washer

4. Remove the screwdriver .

ATTACHING THE PLASTIC SHIELD

WARNING: The shield must be prop-

erly installed. The shield provides partial

protection from the risk of thrown objects to

the operator and others and is equipped with a

line limiter blade which cuts excess line to the

proper length. The line limiter blade (on under-

side of shield) is sharp and can cut you.

1. Remove wing nut from shield.

2. Insert bracket into slot on shield.

3. Pivot shield until bolt passes through hole

in bracket.

4. Tighten the wing nut securely.

Wing Nut

Bracket

Slot

Shield

Gearbox

PIVOT

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire