Poulan 115261126 Manuel d'utilisateur télécharger pdf (Page 8)

OPERATION

KNOW YOUR PRUNER ATTACHMENT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA T ING YOUR

PRUNER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with

the location of the various controls and adjustments. Save this manual for future reference.

Shaft

Pruner

Chain

Bar

Bar Nut

Hanger

Extension Shaft

Bar Oil Fill Cap

PRUNER

The PRUNER is designed for removal of

limbs and branches overhead not greater

than 6 inches (15 cm) in diameter .

CHAIN TENSION

It is normal for a new chain to stretch during

first 15 minutes of operation. You should

check your chain tension frequently. See

CHAIN TENSION in the SERVICE AND AD-

JUSTMENTS section.

OPERATING THE COUPLER

Your unit is equipped with a coupler system

which enables optional attachments to be

installed. The optional attachments are:

MODEL:

Edger PPB1000E.....................

Cultivator PPB2000T..................

Blower PPB3000B....................

Pruner PPB5000P....................

Brushcutter* PPB4000C...............

*not designed for use with electric-powered

units.

WARNING: Always stop unit and dis-

connect spark plug wire (or disconnect unit

from power source) before removing or instal-

ling attachments.

REMOVING PRUNER ATTACHMENT

(OR OTHER OPTIONAL AT TACH-

MENTS)

CAUTION:

When removing or installing at-

tachments, place the unit and attachment on

a flat surface for stability.

1. Loosen the coupler by turning the knob

counterclockwise.

Attachment

Coupler

Knob

LOOSEN

TIGHTEN

2. Press and hold the locking/release button.

Locking/Release

Button

Coupler

Upper Shaft

Attachment

3. While securely holding the engine end shaft

and extension shaft, pull the attachment

straight out of the extension shaft coupler.

4. Repeat steps to remove extension shaft

from coupler on engine end shaft.

INSTALLING OPTIONAL ATTACH-

MENTS

CAUTION:

DO NOT use extension shaft

with other optional attachments.

1. Remove the shaft cap from the attachment

(if present) and discard.

2. Position locking/release button of attach-

ment into guide recess of coupler on engine

end shaft.

3. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

4. Before using the unit, tighten the knob se-

curely by turning clockwise.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Poulan 115261126 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Poulan 115261126