Poulan PLN1514 Manuel d'utilisateur télécharger pdf (Page 9)

2. The extension cord must be

specifically intended for outdoor use

and marked SW-A, SOW*A, STW-A,

STOW-A, SJW-A, SJOW-A,

SJTOW-A, STJW, or SJTW.

3. Inspect the extension power cord for

loose or exposed wires and

damaged insulation,If damaged,

replace before using the appliance.

WARNING

Do not operate your chain saw in a

wet or damp environment. Do not

expose the saw to rain, snow or

sleet. Moisture will cause short

circuits. Replace or repair any

damaged or frayed extension cords

before using your saw. Keep the cord

away from the cutting area and position

the cord so that it will not be caught

on branches or other objects during

cutting.

4-4A

SAVE THESE

INSTRUCTIONS

DOUBLE INSULATION PNO

SERVICEABLE PARTSINSIDE

Do not use if the cord or plug is

damaged.Your appliance is double

insulated to help protect against electric

shock. Double insulation construction

consists of two{2) separate '1ayers"of

electrical insulation.

Appliances built a double this insulation

system are not intended to be

grounded.As a result, the extension

cord usedwith your appliance can be

plugged into any conventional 120 volt

electrical outlet.

Normal safety precautions must be

observed when operating an electrical

appiiance.The double insulation system

is only for added protection against

injury resuiting from a possible internal

electrical insulation failure.

WARNING

Your double insulated appliance has no

serviceable parts inside. Do not attempt

to repair it yourself.For service

information, contact the Poulan Product

Service Department toll-free number

listed on the back cover of this manual.

5 - GENERAL CUTTING INSTRUCTIONS

5-1. FELLING

Felling is the term for cutting down a

tree.Small trees up to 6-7”(l5-18cm) in

diameter are usually cut in a single cut.

Larger trees require notch cuts.Notch

cuts determine the direction the tree will

fall.

FELLING A TREE:

WARNING

A retreat path (A) should be planned

and cleared as necessary before cuts

are started. The retreat path should

extend back and diagonally to the rear

of the expected tine of fall, as illustrated

in Figure 5-1A.

CAUTION

If felling a tree on sloping ground, the

chain saw operator should keep on the

uphill side of the terrain, as the tree is

likely to roil or slide downhill after it is

felled.

NOTE:Direction of fall (8) is controlled

by the notching cut. Before any cuts

are made, consider the location of

larger branches and natural lean of the

tree to determine the way the tree will

fall.

C?i

'C,

5-1A

WARNING

Do not cut down a tree during high or

changing winds or if there is a danger

to property. Consult a tree professional.

Do not cut down a tree if there is a

danger of striking utility wires;notify the

utility company before making any cuts.

GENERAL GUIDELINES FOR

FELLING TREES:

Normally felling consists of 2 main

cutting operations, notching (C) and

making the felling cut (D).

Start making the upper notch cut (C) on

the side of the tree facing the felling

direction (E).Be sure you don’t make

the lower cut too deep into the trunk.

The notch (C) should be deep enough

to create a hinge (F) of sufficient width

and strength.The notch should be wide

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire