Poulan PLN1510 Manuel d'utilisateur Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
4 - OPERATING INSTRUCTIONS
4-1. TO START SAW
1. PLEASE READ ALL WARNINGS.
2. Make sure oil reservoir is full.
WARNING
Ensure the extension cord is of the
proper size and type for your saw,
3. Plug the cord (A) into the appropria
te size extension cord {B} (see Figu
re 3-11). Plug the extension cord
into a 110/120 volt AC, 15 AMP
receptacle (Figure 4-1 A),
WARNING
Make sure the extension cord does not
come in contact with the guide bar and
saw chain.
4. Grip the saw with both hands, left
hand holding the front handle and
the right hand holding the rear
handle. Thumbs and fingers should
encircle both handles (Figure 4-1B).
5. With your RIGHT THUMB, depress
the LOCK/OFF button (C) on the
side of the rear handle, and at the
same time squeeze the trigger. To
stop the saw, release the trigger
(Figure 4-1C).
NOTE: It is not necessary to maintain
pressure on the LOCK/OFF button once
the trigger is squeezed and the motor is
running. The LOCK/OFF button is a saf
ety device to avoid accidental starting.
4-1C
4-2. TO STOP MOTOR
The saw motor will automaticaliy stop
when the trigger is released. The LOCK
/OFF button will have to be depressed
and the trigger squeezed to restart the
motor.
4-3. CHAIN AND BAR
LUBRICATION
Always check oil level before using
saw.To oil chain, press oil cap.Do not
attempt to operate the oiler while cutting
with the saw. Oil will feed onto guide
bar and chain. Press oil capat least
once before each cut.Check oil level
often.
CAUTION
Never starve the bar and chain of
lubrication oil. Running the saw DRY or
with TOO LITTLE OIL will decrease
cutting efficiency, shorten chain saw
life, and cause rapid dulling of the chain
and excessive wear of the bar from
overheating. Too little oil is evidenced
by smoke or bar discoloration.
NOTE: The saw chain stretches during
use, particuiarly when it is new, and
occasional adjustment will be needed.
A new chain requires more frequent
adjustment during the break-in period.
This is normal.See Section 3-5 for Saw
Chain Tension Adjustment instructions.
WARNING / CAUTION
A loose chain can jump off the bar while
you are cutting, as well as wear the bar
and chain.A chain that is too tight can
damage the saw.Either situation, chain
too loose or too tight, could cause
serious personal injury.
4-4. EXTENSION CORDS
When using an electric chain saw, plug
it into the extension cord only when you
are ready to cut wood.Connect the ext
ension cord to a 110/120 voltage outlet.
NOTE: To prevent disconnection of the
extension cord, tie a loose knot before
connecting the ends together (Figure
4-4A).
CAUTION
A cord that is hot to the touch is
overloaded.
1. When using the chain saw. an exte
nsion cord of adequate size must be
used for safety and to prevent loss
of power and overheating.
2. The extension cord must be specific-
10
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire