PoulcMi*^Please do not return unit to retailer.Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au dét
4 - OPERATING INSTRUCTIONS4-1. TO START SAW1. PLEASE READ ALL WARNINGS.2. Make sure oil reservoir is full.WARNINGEnsure the extension cord is of the
ally intended for outdoor use and marked SW-A, SOW-A, STW-A, STOW-A, SJW-A, SJOW-A, SJTOW-A, STJW, or SJTW.3. Inspect the extension power cord for lo
cuts determine the direction the tree wili fall.FELLING A TREE:WARNINGA retreat path (A) should be planned and cleared as necessary before cuts are st
5-3. LIMBINGLimbing a tree is the process of removing the branches from a fallen tree. Do not remove supporting limbs (A) until after the log is buck
6 BAR/CHAÍN MAINTENANCE6-í. GUIDE BAR MAINTENANCEWARNINGEnsure that the power cord is disconnected before performing any maintenance on your saw.Pro
WARNINGAlways wear heavy duty protection wo- rk gloves and disconnect the extension cord when working on the saw chain. CHAIN TENSION:Check the chain
8 - LIMITED WARRANTYPoulan , a division of Husqvarna Consumer Outdoor Products N.A., Inc,, warrants to the original consumer purchaser that each new P
1 - GENERAL INFORMATIONi-7. GENERAL IDENTIFICATION1.Saw Chain12.Hand Guard2.Guide Bar13.Oil Tank Cap3.Front Handie14.Electric Motor4.Handle Bracket15.
SPECIFICATIONinput ...120V-, 6OH2. 8AmpPeak Horsepower...
5. GUARD AGAINST ELECTRIC SHOCK: Prevent body contact with grounded surfaces (i.e., nnetal pipes, wire fences).6. CONStDER THE WORK AREA ENVIRONMENT
A. GRIP SAW FIRMLY; Hold the chain saw firmly with both hands when the motor is running. Keep a good firm grip on the saw with both hands, the right
Use only the chain and bar suppled with this product. Do not use any other cutting attachment. Use of such attachments will void your factory warrant
Contact of the guide bar tip with any object should be avoided. Tip contact may cause the guide bar to move suddeniy upward and backward, which may ca
3-5. SAW CHAIN TENSION ADJUSTMENTProper tension of the saw chain is extremely important and must be checked before starting, as well as during, any c
4, Piug the saw power cord into receptacie cord at end of inner pole.3-6A3-7. ADJUSTING POLB LENGTHThe pole saw has a telescoping pole assembly that w