Poulan P3500 Manuel d'utilisateur télécharger pdf (Page 5)

5

USING YOUR UNIT

S

Do not change the engine governor set-

tings or over speed the engine.

S

If the product vibrates abnormally, immedi-

ately stop the engine and check for the

cause. Vibration is generally a warning of

trouble.

S

Stop the engine whenever you leave the

operation position; disconnect the spark

plug lead before unclogging the cutting

member guard, when making a repair, ad-

justment, inspection, or the like.

S

Operate product from position where

guards block the line of sight to the cutting

member.

SETTING THE DEPTH OF THE

WHEEL

WARNING:

Never attempt to adjust

the wheel when the engine is running. Always

stop the engine, wait until the blade stops

turning and disconnect the spark plug before

making adjustments.

S

Loosen plastic knob on the blade guard.

S

Raise or lower the wheel to obtain desired

edging depth.

S

Tighten knob hand tight.

NOTE:

If area has not been edged for sever-

al weeks, do not cut deeper than 1/2 inch the

first time.

SERVICE

We recommend all service and adjustments

not listed in this manual be performed by an

Authorized Service Dealer.

CARBURETOR ADJUSTMENTS

Your carburetor is equipped w ith limiter caps.

Damage will occur if you turn the needles be-

yond the limiter caps. Carbur etor adjustment is

a complicated task. We recom mend that you

take your unit to an Authorized Service Dealer.

IGNITION TIMING

Ignition timing is fixed, non-adjustable.

SPARK PLUG

Replace spark plug yearly with a Champion

RC J- 8Y plug; spark plug gap is .025 inches.

TROUBLE CAUSE REMEDY

Engine will not

start.

S

Engine flooded.

S

Fuel tank empty.

S

Spark plug not firing.

S

Fuel not reaching

carburetor.

S

Carburetor requires

adjustment.

S

See “Starting.”

S

Fill tank with correct fuel mixture.

S

Install new spark plug.

S

Check for dirty fuel filter; replace.

Check for kinked or split fuel line;

repair or replace.

S

Contact your Service Dealer.

Engine will not

idle properly.

S

Carburetor requires

adjustment.

S

Throttle trigger screw

too tight.

S

See “Carburetor Adjustments.”

S

Loosen screw .

S

Air filter dirty.

S

Spark plug fouled.

S

Carburetor requires

adjustment.

Engine will not

accelerate,

lacks power, or

dies under a

load.

S

Clean or replace air filter.

S

Clean or replace spark plug

and re-gap.

S

See “Carburetor Adjustments.”

Engine smokes

excessively .

S

Fuel mixture incorrect.

S

Air filter dirty.

S

Carburetor requires

adjustment.

S

Empty fuel tank and refill with

correct fuel mixture.

S

Clean or replace air filter.

S

See “Carburetor Adjustments.”

TROUBLESHOOTING TABLE

WARNING:

Always stop unit and disconnect spark plug before performing any

of the recommended remedies below other than remedies that require operation of

the unit.

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire