Poulan 530163467 Manuel d'utilisateur télécharger pdf (Page 8)

8

Coupler

Knob

LOOSEN

TIGHTEN

Upper Shaft

Lower

Attachment

2. Press and hold the locking/release button.

L

ocking

/

Release

Button

Coupler

Upper Shaft

Lower Attachment

3. While securely holding the upper shaft,

pull the attachment straight out of the cou-

pler.

INSTALLING OPTIONAL ATTACH -

MENTS

1. Remove the shaft cap from the attachment

(if present) and discard.

2. Position locking/release button of attach-

ment into guide recess of upper shaft cou-

pler.

Coupler

Primary Hole

Upper

Shaft

Locking/

Release

Button

Attachment

Guide Recess

3. Push the attachment into the coupler until

the locking/release button snaps into the

primary hole.

4. Before using the unit, tighten the knob se-

curely by turning clockwise.

WARNING: Make sure the locking/

release button is locked in the primary hole

and the knob is securely tightened before op-

erating the unit.

BAR AND C HAIN LUBRICATION

The bar and chain require lubrication. The

chain oiler provides continuous lubrication to

the chain and guide bar. Be sure to fill the bar

oil tank before use (Capacity = 4.6 fl. oz.).

Lack of oil will quickly ruin the bar and chain.

Too little oil will cause overheating shown by

smoke coming from the chain and/or discolor-

ation of the bar . The oil output is automatically

metered during operation.

Genuine PoulanR or Poulan PROR bar and

chain oil is recommended to protect your unit

against excessive wear from heat and fric-

tion. PoulanR or Poulan PROR oil resists

high temperature thinning. If PoulanR or

Poulan PROR bar and chain oil is not avail-

able, use a good grade SAE 30 oil.

S Never use waste oil for bar and chain lubri-

cation.

S Always stop the engine before removing

the oil cap.

INSTALLING ATTACHMENT

HANGER

An attachment hanger is provided for storage

when attachment is not in use.

To install hanger on attachment:

1. Remove the shaft cap from the attachment

(if present) and discard.

2. Press and hold the locking/release button.

3. Push hanger onto the attachment until the

locking/release button snaps into the hole.

OPERATING POSITION

Eye

Protection

ALWAYS WEAR:

Long Pants

Heavy Shoes

Head

Protection

DANGER: Do not extend arms above

shoulders while pruning. Do not stand be-

neath branch being cut.

WARNING: Always wear head, eye,

hearing, foot and body protection to reduce

the risk of injury when operating this unit.

When operating unit, clip shoulder strap onto

clamp, stand as shown and check for the fol-

lowing:

S Extend your left arm and hold assist handle

with your left hand.

S Hold throttle grip with your right hand with

finger on throttle trigger.

S Keep engine end below waist level.

S Keep shoulder strap pad centered on your

left shoulder and danger sign centered on

your back.

S Maintain full weight of tool on your left

shoulder.

PRUNING

WARNING: Be alert for and guard

against kickback. Do not allow the moving

chain to contact any other branches or ob-

jects at the nose of the guide bar when prun-

ing. Allowing such contact can result in seri-

ous injury.

IMPORTAN T POINTS

S Work slowly, keeping both hands firmly

gripped on the pruner. Maintain secure

footing and balance.

S Plan cut carefully. Check direction branch

will fall.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire