Poulan 4400 Manuel d'utilisateur

Poulan—4400/^900/5400Counter VibeCAUTION:Read Rules for Safe Operation Carefully. Note Special Instructions for Bow Saw Users.BEAIRD-POULAN/WEED EATER

REPLACING DRUM AND SPROCKETWARWING!—Do not start engine without guide bar, chain, and bar clamp completely assembled. The clutch can come off without

CARBURETOR ADJUSTMENT (Model 4400/4900/5400)STOP THE ENGINE ~ Make sure you are using clean, freshfuel mixture at the correct gasoline/oil ratio. THE

STARTER ROPEIf your starter rope breaks near the pulley, it can be repaired by the following method, otherwise replace the rope:1. Remove

TROUBLE SHOOTINGTROUBLECAUSEREMEDYElMGilME WONT START1. Switch off,2. Empty fuel tank.3. Spark plug not firing.4. Fuel not getting to carburetor.5

TABLE OF CONTENTSBar and Chain Installation . , .Chain Adjustment ...Bow Installation ...Operating Instructions

SAFETY FEATURESYour new chain saw is equipped with guard link safety chain to reduce kickback.A hand guard is provided to protect you

INSTALLING THE GUIDE BAR AND SAFETY CHAIN (con't)Figure 44. Place the chain over the sprocket and engage the drive link tangs between

OPERATING INSTRUCTIONS (cont'd)STARTINGMove bystanders and obstructions well out of reach!WARNIMG; Chain will be moving when engine starts. Make

BUCKINGBucking is the sawing of a log or fallen tree into smaller pieces. (See Figúrelo)□ Use Both Hands — grip the saw firmly. (See Figure 11.)□ St

BOW INSTALLATIONTo install a bow guide to a standard guide bar model it is necessary to modify the bar clamp and saw body asRef.No.Part N

Your Planning and Preparation• Do not handle or operate a chain saw when you are fatigued or tired, have been drinking alcoholic bev

OPERATING YOUR CHAIN SAWi Wear your protective gear.^ Before you start the engine, make sure the saw chain is not contacting anything.^ Keep