Poulan 530163323 Manuel d'utilisateur télécharger pdf (Page 10)

10

S

Never use waste oil for bar and chain

lubrication.

S

Always stop the engine before removing

the oil cap.

IMPORTANT

Experience indicates that alcohol blended

fuels (called gasohol or using ethanol or

methanol) can attract moisture which leads to

separation and formation of acids during stor-

age. Acidic gas can damage the fuel system

of an engine while in storage. To avoid engine

problems, empty the fuel system before stor-

age for 30 days or longer. Drain the gas tank,

start the engine and let it run until the fuel lines

and carburetor are empty. Use fresh fuel next

season. Never use engine or carburetor

cleaner products in the fuel tank or permanent

damage may occur.

See the STORAGE section for additional in-

formation.

HOW TO STOP YOUR UNIT

S

To stop the engine, move the ON/OFF

switch to the OFF position.

S

If engine does not stop, move choke lever

to the FULL CHOKE position.

ON/OFF Switch

HOW TO START YOUR UNIT

WARNING:

Make sure the chain will

not make contact with any object while start-

ing the engine. Never try to start the unit when

the guide bar is in a cut. Avoid any contact

with the muffler. A hot muffler can cause seri-

ous burns.

STARTING A COLD ENGINE (or a

warm engine after running out of

fuel)

Starting Position

Muffler

Choke

Lever

Starter Handle

Primer Bulb

1. Set unit on a flat surface.

2. Move ON/OFF switch to the ON position.

3. Slowly press the primer bulb 6 times.

4. Move choke lever to FULL CHOKE by

aligning lever with position shown on de-

cal (see illustration below).

Choke

position

decal

5. Squeeze the throttle trigger fully and hold

through

all remaining steps.

6. Pull starter rope handle sharply until en-

gine sounds as if it is trying to start, but do

not pull rope more than 6 times.

7. As soon as engine sounds as if it is trying

to start, move choke lever to HALF

CHOKE by aligning lever with position

shown on decal (see illustration below).

Choke

position

decal

8. Pull starter rope sharply until engine runs,

but no more than 6 pulls. If the engine

doesn’t star t after 6 pulls (at the HALF

CH OKE position), move the choke lever to

the FULL CH O KE position and press the

primer bulb 6 times. Squeeze and hold the

throttle trigger and pull the starter rope 2

more time s . Mo v e the ch o k e lev e r to the

HALF CHOKE position and pull the starter

rope until the engine runs, but no more than

6 pulls. If the engine doesn’t start, r epeat

procedure 2 additional times.

NOTE:

If engine still doesn’t start, it is

probably flooded. Proceed to STARTING A

FLOODED ENGINE.

9. Once the engine starts, allowit to run 10 se-

conds, then move the choke lever to OFF

CH OKE by aligning lever with position

shown on decal (see illustration below). Al-

low the unit to run for 30 more seconds at

OFF CH O KE before releasing the throttle

trigger.

NOTE:

If engine dies with the

choke lever in the OFF CHO KE position,

move the choke lever to the HALF CHOKE

position and pull the rope until engine runs,

but no more than 6 pulls.

Choke

position

decal

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire