Poulan 115225426 Manuel d'utilisateur télécharger pdf (Page 10)

ADJUSTING THE HANDLE

WARNING: When adjusting the han-

dle, be sure it remains above the safety label

and below the mark or arrow on the shaft.

1. Loosen wing nut on handle.

2. Rotate the handle on the shaft to an up-

right position; retighten wing nut.

OPERATION

KNOW YOUR UNIT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT.

Compare the illustrations with your unit to familiarize yourself with the location of the various controls

and adjustments. Save this manual for future reference.

Line limiter

blade

Assist handle

Shield

Trimmer head

Shaft

ON/STOP switch

Coupler

Primer bulb

Starter handle

Choke lever

Muffler

Throttle trigger

Throttle lock--out

ON/STOP SWITCH

The ON/STOP switch is used to stop engine. To

stop the engine, move the switch to the STOP

position.

PRIMER BULB

The PRIMER BULB removes air from the car-

buretor and fuel lines and fills them with fuel.

This allows you to start the engine with fewer

pulls on the starter rope. Activate the primer

bulb by pressing it and allowing it to return to

its original form.

CHOKE

The CHOKE helps to supply fuel to the engine

toaidincoldstarting.Activatethechokeby

moving the choke lever to the FULL CHOKE

position. After the engine attempts to start, move

the choke lever to the HALF CHOKE position.

Once engine has started, move the choke lever

to the RUN position.

COUPLER

The COUPLER enables optional attach-

ments to be installed on the unit.

BEFORE STARTING ENGINE

WARNING: Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING: Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2--cycle sy nthetic oil into

one gallon of fresh gas.

This engine is certified to operate on unleaded

gasoline. Before operation, gasoline must be

mixed with a good quality synthetic 2-cycle air-

cooled engine oil designed to be mixed at a ratio

of 40:1. Poulan/WEED EA TER brand synthetic

oil is recommended. Mix gasoline and oil at a ra-

tio of 40:1. A 40:1 ratio is obtained by mixing 3.2

fluid ounces (95 ml) of oil with 1 gallon (4 liters)

of unleaded gasoline. DO NOT USE automotive

oil or marine oil. These oils will cause engine

damage. When mixing fuel, follow instructions

printed on container. Once oil is added to gaso-

line, shake container momentarily to assure that

the fuel is thoroughly mixed. Always read and

follow the safety rules relating to fuel before fuel-

ing your unit.

CAUTION: Never use straight gasoline in

your unit. This will cause permanent engine

damage and void the limited warranty.

FUEL REQUIREMENTS

This engine requires the use of minimum 87

octane [R+M]/2 clean gasoline.

IMPORTANT

Use of alcohol blended fuels (called gasohol or

using ethanol or methanol) can cause major en-

gine performance and durability problems.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Commentaires sur ces manuels

Pas de commentaire

Poulan 115225426 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Poulan 115225426