Poulan 420077 Manuel d'utilisateur télécharger pdf (Page 17)

MAINTENANCE

Only the parts shown on the parts list are intended to

be repaired or replaced by the customer. All other parts

should be replaced at a Poulan Pro Authorized Service

Center.

GENERAL MAINTENANCE

Keep the generator in a clean and dry environment

where it is not exposed to dust, dirt, moisture, or cor-

rosive vapors. Do not allow the cooling air slots in the

generator to become clogged with foreign material such

as leaves, snow, etc.

Do not use a garden hose to clean the generator. Water

entering the fuel system or other internal parts of the

unit can cause problems that will decrease the life of the

generator.

To clean the unit:

■ Use a soft bristle brush and/or vacuum cleaner to

loosen and remove dirt and debris.

■ Clean air vents with low pressure air that does not

exceed 25 psi.

■ Wipe the exterior surfaces of the generator with a

damp cloth.

CLEANING/REPLACING AIR FILTERS

See Figure 13.

For proper performance and long life, keep air filters clean:

■ Release the upper and lower retaining clips and

remove the air filter cover.

■ Remove the outer filter element and the inner

precleaner element.

■ If the filter elements are dirty, clean with warm, soapy

water. Rinse and let dry.

■ Apply a light coat of engine oil to the elements, then

squeeze it out.

■ Put the filter elements back together and replace

in the air filter compartment, being careful to place

the outer filter element closest to the air filter cover.

■ Replace the cover and snap retaining clips back in

place to secure.

NOTE: Do not run the generator without the air filters.

Rapid engine wear will result.

WARNING:

When servicing, use only identical Poulan Pro

replacement parts. Use of any other parts may

create a hazard or cause product damage.

CHANGING ENGINE OIL

See Figure 14

■ Remove the oil dipstick.

■ Place a container underneath the oil drainage bolt

to collect used oil as it drains.

■ Unscrew the oil drainage bolt and remove.

■ Allow oil to drain completely.

■ Reinstall the oil drainage bolt and tighten securely.

■ Refill with oil following the instructions in the

“Checking/Adding Oil” section on page 14.

NOTE: Disposal of used oil should be at an approved

disposal site. See your local oil retailer for more information.

Fig. 14

Fig. 13

OIL FILL

TUBE

OIL DRAINAGE

BOLT

OIL DIPSTICK

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Poulan 420077 Manuel d'utilisateur Page 17

Commentaires sur ces manuels