Poulan PP336 Manuel d'utilisateur télécharger pdf (Page 9)

9

Throttle Trigger

ON/OFF

Switch

HOW TO S TART YOUR UN IT

WARNING: Avoid any contact with

the muffler. A hot muffler can cause serious

burns.

HELPFUL TIP

If your engine still does not

start after following these

instructions, please call

1--800--554--6723.

STARTING A COLD ENGINE (or a

warm engine after running out of

fuel)

Starting Position

Muffler

Choke

Lever

Starter Handle

Primer Bulb

1. Set unit on a flat surface.

2. Move ON/OFF switch to the ON position.

3. Slowly press the primer bulb 6 times.

4. Move choke lever to FULL CHOKE by

aligning lever with position shown on de-

cal (see illustration below).

Choke

position

decal

5. Squeeze the throttle trigger fully and hold

through all remaining steps.

6. Pull starter rope handle sharply until en-

gine sounds as if it is trying to start, but do

not pull rope more than 6 times.

7. As soon as engine sounds as if it is trying

to start, move choke lever to HALF

CHOKE by aligning lever with position

shown on decal (see illustration below).

Choke

position

decal

8. Pull starter rope sharply until engine runs,

but no more than 6 pulls. If the engine

doesn’t start after 6 pulls (at the HALF

CHOKE position), move the choke lever to

the FULL CHOKE position and press the

primer bulb 6 times. Squeeze and hold the

throttle trigger and pull the starter rope 2

m ore time s. Mo ve the cho k e lever to the

HALF CHOKE position and pull the starter

rope until the engine runs, but no more than

6 pulls. If the engine doesn’t start, repeat

procedure 2 additional times.

NOTE: If engine still doesn’t start, it is

probably flooded. Proceed to ST ARTING A

FL OODE D ENGINE .

9. Once the engine starts, allow it to run 10 se-

con d s, then mo ve the choke lever to OFF

CHOKE by align ing le ver with position

shown on decal (see illustrati on below). Al-

low the unit to run for 30 more seconds at

OFF CHOKE before releasing the throttle

trigger.

NOTE: If engine dies with the

choke lever in the OFF CHOKE position,

mo ve t h e cho ke lever to t h e HALF CHOKE

position and pull the rope until engine runs,

but no more than 6 pulls.

Choke

position

decal

STARTING A WARM ENGINE

1. Move ON/OFF switch to the ON position.

2. Move the choke lever to the HALF

CHOKE position.

3. Squeeze and hold the throttle trigger.

Keep throttle trigger fully squeezed until

the engine runs smoothly .

4. Pull starter rope sharply until engine runs,

but no more than 5 pulls.

5. Allow engine to run 15 seconds, then

move the choke lever to the OFF CHOKE

position.

NOTE: If engine has not started, pull starter

rope 5 more pulls. If engine still does not run, it

is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing

the choke lever in the OFF CHOKE position;

then, pull the rope to clear the engine of ex-

cess fuel. This could require pulling the starter

handle many times depending on how badly

the unit is flooded.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire