Poulan PP336 Manuel d'utilisateur télécharger pdf (Page 5)

5

Locking/Release

Button in Primary Hole

Secondary Hole

For optional attachments, see the AS-

SEMBLY section of the applicable attach-

ment instruction manual.

ATTACHING THE HANDLEBAR

DANGER: To avoid serious injury , the

barrier portion of the handlebar must be installed

as shown to provide a barrier between operator

and the spinning blade.

1. Locate the decal on the handlebar. This

decal includes an arrow. Position the

handlebar with the mounting bracket at

the end of the arrow .

2. Position the bracket cover over the han-

dlebar. Again make sure the handlebar is

at the end of the arrow.

3. Insert screws and hand tighten only . Be

sure the handlebar is installed correctly;

then, tighten each screw securely with

the hex wrench.

Screw

Mounting

Bracket

Handlebar

Bracket Cover

ASSEMBLY OF SHOULDER STRAP

WARNING: Proper shoulder strap

and handlebar adjustments must be made

with the engine completely stopped before

using unit.

1. Insert your right arm and head through

the shoulder strap and allow it to rest on

your left shoulder. Make sure the danger

sign is on your back and the hook is to the

right side of your waist.

NOTE: A one-half twist is built in the shoul-

der strap to allow the strap to rest flat on the

shoulder.

2. Adjust the strap, allowing the hook to be

about 6 inches (15 cm) below the waist.

3. Fasten the strap hook to the clamp located

between the trigger handle and the handle-

bar clamp base and lift the tool to the oper-

ating position.

4. Try on shoulder strap and adjust for fit

and balance before starting the engine or

beginning a cutting operation.

NOTE: It may be necessary to relocate the

shoulder strap clamp on the shaft for proper

balancing of unit.

TO RELOCATE SHOULDER STRAP

CLAMP:

1. Loosen and remove both clamp screws.

2. Place the upper shoulder strap clamp

over the shaft.

3. Position the lower shoulder strap clamp

under the shaft and align the upper and

lower clamp screw holes.

Upper Shoulder

Strap Clamp

Screws

Lower Shoulder

Strap Clamp

4. Insert two screws into the screw holes.

5. Secure shoulder strap clamp by tighten-

ing screws with a hex wrench.

30 inches

(76 cm)

HARNESS

ADJUSTMENT

FOR BALANCE

4 -- 12 inches

(10 -- 30 c m)

above

ground

6 inches

(15 cm)

below

waist

30 inches

(76 cm)

CONFIGURING YOU R UNIT

You can configure your unit using a cutting head

for grass and light weeds, or a weed blade for

cutting grass, weeds, and brush up to 1/2 inch

(1 cm) in diameter . To assemble your unit, go to

the section for the desired configuration and fol-

low the instructions.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commentaires sur ces manuels

Pas de commentaire