Poulan PO14542LT Manuel d'utilisateur télécharger pdf (Page 6)

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard

wrench sizes are listed.

(1) 9/16" wrench Pliers

(2) 1/2" wrenches Tire pressure gauge

Utility knife

When right or left hand is mentioned in this manual, it means

when you are in the operating position (seated behind the

steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Cut, from top to bottom, along lines on all four corners

of carton, and lay panels flat.

• Check for any additional loose parts or cartons and

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To

ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the

correct tools as necessary to insure proper tightness.

FIG. 1

BEFORE REMOVING TRACTOR FROM

SKID

ATTACH STEERING WHEEL (See Fig. 1)

ASSEMBLE EXTENSION SHAFT AND BOOT

• Slide extension shaft onto lower steering shaft. Align

mounting holes in extension and lower shafts and install

5/16 hex bolt and locknut. Tighten securely.

• Place tabs of steering boot over tab slots in dash and

push down to secure.

INSTALL STEERING WHEEL

• Position front wheels of the tractor so they are pointing

straight forward.

• Remove steering wheel adapter from steering wheel and

slide adapter onto steering shaft extension.

• Position steering wheel so cross bars are horizontal (left

to right) and slide inside boot and onto adapter.

• Assemble large flat washer, 3/8 lock washer, 3/8 hex

bolt and tighten securely.

• Snap steering wheel insert into center of steering wheel.

• Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES

IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR

IS TO ROLL OFF SKID.

5/16 LOCKNUT

LOWER

STEERING

SHAFT

STEERING

BOOT

EXTENSION SHAFT

5/16 HEX BOLT

STEERING

WHEEL

INSERT

ADAPTER

3/8 HEX BOLT

3/8 LOCK WASHER

LARGE FLAT

WASHER

TABS

TAB

SLOTS

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Poulan PO14542LT Manuel d'utilisateur Page 6

Commentaires sur ces manuels