Poulan PO14542LT Manuel d'utilisateur télécharger pdf (Page 23)

SERVICE AND ADJUSTMENTS

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run

poorly, stop running, or prevent it from starting.

• Check wiring. See electrical wiring diagram in the Repair

Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse

holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 29)

• Raise hood.

• Unsnap headlight wire connector.

• Stand in front of tractor. Grasp hood at sides, tilt toward

engine and lift off of tractor.

• To replace, reverse above procedure.

FIG. 29

HEADLIGHT

WIRE

CONNECTOR

HOOD

FIG. 28

KEPS

NUT

HEX

BOLT

POSITIVE (RED)

CABLE

NEGATIVE

(BLACK) CABLE

TO REPLACE HEADLIGHT BULB

• Raise hood.

• Pull bulb holder out of the hole in the backside of the grill.

• Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

• Close hood.

GOVERNOR

CONTROL LEVER

GOVERNOR

CONTROL

PLATE

THROTTLE

CABLE

HOLES “A”

FIG. 30

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjust-

ment should not be necessary. However, minor adjustment

may be required to compensate for differences in fuel,

temperature, altitude or load. If the carburetor does need

adjustment, see engine manual.

High speed stop is factory adjusted. Do not adjust - damage

may result.

IMPORTANT: NEVER TAMPER WITH THE ENGINE

GOVERNOR, WHICH IS FACTORY SET FOR PROPER

ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE

THE FACTORY HIGH SPEED SETTING CAN BE

DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED

HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR

NEAREST AUTHORIZED SERVICE CENTER/

DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND

EXPERIENCE TO MAKE ANY NECESSARY

ADJUSTMENTS.

ENGINE

CLAMP

SCREW

TO ADJUST THROTTLE CONTROL CABLE

(See Fig. 30)

The throttle control has been preset at the factory and

adjustment should not be necessary. Check adjustment as

described below before loosening cable. If adjustment is

necessary, proceed as follows:

• With engine not running, move throttle control lever from

slow to choke position. Slowly move lever from choke

to fast position.

• Check that holes “A” in governor control lever and hole

in governor plate line-up. If holes “A” are not aligned,

loosen clamp screw and move throttle cable until holes

are aligned. Tighten clamp screw securely.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Poulan PO14542LT Manuel d'utilisateur Page 23

Commentaires sur ces manuels