Poulan PPBP30-9096320642 Manuel d'utilisateur

Poukin PR0Please do not return unit to retailer.Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant.

6-2C7 - MAINTENANCE INSTRUCTIONS7-1. MAINTENANCE SCHEDULEPerform maintenance procedures a! the frequency stated in the table. These procedures should

7-2. AIR FILTERCAUTIONNEVER operate biower without the air filter. The air filter must be kept dean, ff it becomes damaged, install a new filter.TO CL

.025" {.635mtn)SparkPlug7-5 B7-6. SPARK ARRESTOR SCREEN / COLLAR ASSEMBLY1. To replace spark arrestor screen/collar assembly (A) (Fig, 7-5B}, us

9 ~ UMITED WARRANTYPoulan PRO, a division of Husqvarna Consumer Outdoor Products N.A., Inc., warrants to the original consumer purchaser that each new

U.S. EPA/CALIFORNIA/ENVIRONMENT CANADA EMISSIONS CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONS: The U.S. Environmental Protection Age

The information on the product label indicates which standard your engine is certified. Example: (Year) EPA and/or CALIFORNIA.POUUNPRO ¡mslSEPAANOCAUF

1 - GENERAL ÍNFORMATION1-1.1,GENEBAL IDENTlFlCATtONthrottle trigger13, CONTROL HANDLE2. THROTTLE ADJUSTER14, OPERATING TUBE3.ON/STOP SWITCH18, HOSE CL

1-2. SPECIFICATIONS ENGINEEngine Type ...

7. STORE EQUIPMENT AWAY FROM POSSIBLE IGNITION SOURCES, such as gas-powered water heaters, clothes dryers, or oil-fired furnaces, portable heaters, e

Secure hair above shoulder length. Do not wear jewelry, loose clothing, or clothing with loosly hanging straps, ties, tassels, etc. They can be caught

4. Attach throttle linkage clips to both ends of the flex tube to secure the throttle cable,(Fig. 3-2D)3-2BTHROTTLE LINKAGE CLIPS3-2C3-3. ATTACH INTE

4 - FUEL AND LUBRICATION4-1. FUELING ENGINEWARNING; Remove fuel cap slowly when refueling.This engine is certified to operate on unleaded gasoline. Be

Pull starter rope slowly until engine sounds as if it is trying to start, but do not pull rope more than 6 times.5, Move choke lever to HALF CHOKE ”

5-2. STOPPING THE ENGINEEmergency Stopping Procedure. When it is necessary to stop blower engine immediately, press and hold the ON/STOP switch (A) un