Poulan EBVM 215 Manuel d'utilisateur télécharger pdf (Page 6)

6

4. To attach the lower vacuum tube to

theupper vacuum tube, first align the

arrowson thetwotubes. Then, press

the two tubes together until thelower

tube is securely seated in the upper

tube (about 3 inches).

Align arrows on upper

and lower tubes

Lower T ubeUpper Tube

COLLECTION BAG ASSEMBLY

1. Open the zipper on the collection

bag and insert the elbow tube.

2. Push the small end of the elbow tube

throughthe small opening in thebag.

NOTE:

Make sure edge of the small

opening is flush against the flared area

of the elbow tube and the hole for the

tube release button is on top.

Small

Opening

Zipper

Opening

Elbow Tube

Tube

Release

Button

Hole

3. Close the zipper on the bag. Make

sure the zipper is closed completely.

4. Align the grooves on the elbow tube

with the grooves on the bloweroutlet.

5. Push the elbow tube onto the blower

outlet until it snaps into place (elbow

tube is secured by red tube release

button).

ADJUSTINGTHE SHOULDERSTRAP

ON THE COLLECTION BAG

1. Carefully loop the shoulder strap

throughthe buckle as shown in theil-

lustration below.

First In

Last In

2. Position the unit on your right-hand

side, blower outlet and bag pointing

toward the rear. Hold the unit in an

upright position with the lower vacu-

um tube on the ground to support it.

3. Place the shoulder strap over your

head and onto your left shoulder.

4. Adjust the strap to allow a free flowof

air from the blower. If the collection

bag is kinked, theunit will notoperate

properly.

NOTE:

The strap is designed to posi-

tion the collection bag on your shoulder

without kinks. The strap is not intended

to support the weight of the unit.

Shoulder strap

on left shoulder

No kinks in bag

allows free air flow

HOW TO CONVERT UNIT FROM

VACUUM USE TO BLOWER USE

1. Stop unit and unplug the extension

cord.

2. Remove the vacuum tubes by insert-

ing the tip of a screwdriver into the

latch area on the vacuum assist han-

dle. Gently tilt handle of screwdriver to-

ward the front of the unit to release the

latch while pulling up on the vacuum

assist handle with your other hand.

Latch Area

Vacuum

Assist

Handle

3. Install the inlet restrictor that was re-

moved when assembling forvacuum

use.

NOTE:

If you are unable to locate the

inlet restrictor, the unit will still operate.

This restrictor improves the blower

function.

4. Remove the collection bag.

5. Close the inlet cover and make sure

it is latched closed.

6. Re-install the blower tube. Refer to

AT-

T ACHING THE BLOWER TUBE

for

instruct ions on how t o attach t his item.

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire