Poulan BV1650 Manuel d'utilisateur télécharger pdf (Page 5)

-- 5 --

ASSEMBLY

WARNING: Stop engine and be sure

the impeller blades have stopped turning be-

fore opening the vacuum inlet door or at-

tempting to insert or remove the vacuum or

blower tubes. The rotating blades can cause

serious injury. Always disconnect the spark

plug before performing maintenance or ac-

cessing movable parts.

WARNING: If you receive your unit

assembled, check each step to insure your

unit is properly assembled and all fasteners

are secure. Follow all safety information in

the manual and on the unit.

D A standard screwdriver is required for as-

sembly.

BLOWER TUBE ASSEMBLY

1. Align the rib on the blower tube with the

groove in the blower outlet; slide the tube

into place.

NOTE: Knob must be loose enough to allow

blower tube to be inserted in blower outlet.

Loosen knob by turning counterclockwise.

Blower

Tube

Blower

Outlet

Rib

Groove

2. Secure the tube by turning the knob clock-

wise.

3. To remove the tube, turn the knob counter-

clockwise to loosen the tube; remove the

tube.

VACUUM BAG A SSEMBLY

1. Open the zipper on the vacuum bag and

insert the elbow tube.

2. Push the small end of the elbow tube

through the small opening in the bag.

Small

Opening

Zipper

Opening

Elbow

Tube

Rib

NOTE: Make sure edge of the small opening

is flush against the flared area of the elbow

tube, and the rib on the elbow tube is on the

bottom.

3. Close the zipper on the bag. Make sure the

zipper is closed completely.

4. Remove blower tube from engine.

Rib

Groove

5. Insert the elbow tube into the blower outlet.

Make sure elbow tube rib is aligned with

the blower outlet groove.

6. Turn knob clockwise to secure elbow tube.

VACUUM TUBE ASSEMBLY

WARNING: Stop engine and be sure

the impeller blades have stopped turning be-

fore opening the vacuum inlet door or at-

tempting to insert or remove the vacuum or

blower tubes. The rotating blades can cause

serious injury.

1. Align the lower vacuum tube as shown.

Push lower vacuum tube into upper vacu-

um tube.

Lower Vacuum Tube

Upper Vacuum

Tube

2. Insert the tip of a screwdriver into the latch

area of the vacuum inlet.

Latch Area

Blower

Outlet

Vacuum

Inlet Cover

Latch

Area

3. Gently tilt the handle of the screwdriver to-

ward the back of the unit to release the

latch while pulling up on the vacuum inlet

cover with your other hand.

4. Hold the vacuum inlet cover open until up-

per vacuum tube is installed.

Vacuum Inlet

Vacuum

Inlet

Cover

Retaining Post

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire